Ambient NanoLockit Handbuch - Seite 8

Blättern Sie online oder laden Sie pdf Handbuch für Zeitschaltuhr Ambient NanoLockit herunter. Ambient NanoLockit 19 Seiten. Timecode + logging
Auch für Ambient NanoLockit: Schnellstart-Handbuch (2 seiten), Schnellstart-Handbuch (2 seiten), Kurzanleitung für die Inbetriebnahme (20 seiten), Schnellstart-Handbuch (5 seiten), Handbuch (4 seiten), Anleitung (5 seiten), Kurzanleitung (2 seiten)

5. Operation Modes

Within the ACN there is always one Lockit device acting as timecode transmitter,

broadcasting timecode and frame rate to the Receivers. You can choose be-

tween C-Jam, TX and Single Jam Mode.

The NanoLockit can act as Single Jam or TX transmitter - and it can recieve a C-Jam

(Continuous Jam) signal by a C-Jam Transmitter (Lockit, LockitSlate or Lockit+).

5.1 Single Jam Mode

On sets where there are only NanoLockit available you can use the Single Jam

Mode for sending a jam to all other NanoLockits on the same ACN Channel.

In Single-Jam Mode you can send a one-time pulse through the ACN to sync all

Lockit devices. From then on, each Lockit continues to run autonomously.

This is perfectly fine for most occasions, as our Lockit devices are highly

accurate and drift less than a frame within 24 hours.

To power up just long-press

All Lockit devices in this mode can send and receive a Single Jam. Choose

one of your Lockits and press

lights up twice.

This way timecode and frame rate gets broadcasted to the other Lockit boxes

in the same ACN channel.

Note: Once a Lockit device is turned off the timecode generator stops. After turning

on again you must perform the Single Jam again.

That's why we recommend C-Jam Mode over

Single Jam Mode, as it completely eliminates

drift and is more convenient to use.

Power.

Green

for 3 seconds until the green LED

Lockit Users manual |