ACR Electronics OLAS CORE Solución de problemas - Página 2
Navegue en línea o descargue pdf Solución de problemas para Accesorios ACR Electronics OLAS CORE. ACR Electronics OLAS CORE 2 páginas. Testing the alarm
También para ACR Electronics OLAS CORE: Manual de inicio rápido (12 páginas), Pruebas de precisión (2 páginas), Configuración y prueba de alcance (4 páginas), Manual (2 páginas), Configuración y prueba de alcance (4 páginas)
Imprimir página
Troubleshooting
7. You should always try to install your Core at least 0.5
meters from any equipment transmitting radio signals
including VHF Radios, antennas and cables.
9. If a false alarm sounds again return to step 1 and increase the Alert Delay at step 5 in increments of 3 seconds.
If false alarms continue after 15 seconds the Core should be moved closer to the point at which the alarm is
being triggered, or an additional OLAS Extender is required to cover the signal 'black spot'.
1m
Tom
Overboard!
Step 1
Press and hold the MOB button
on your GPS Chart Plotter
Step 2
Send a MOB DSC alert
using your VHF
Continue to recovery
Pause Alert Sound
www.acrolas.com
8.
If located within 0.5 meters it is possible false alarms may occur. If you
are experiencing false alarms try moving the Core hub away from
other electrical devices and then carry out the Core setup and range
test to see if the false alarms still occur.
Alert Settings
(Guardian/Core)
Solo Mode
Vessel
0438
Near
Information
0438
Alert Settings
Device Selection
FAQ's
Sound
Close OLAS
Firmware Update
Siren (Default)
Online
Tutorials
MOB
Volume
Alert Delay
+3
6
seconds
Connected to
(Guardian only)
1m
Alert Settings
(Guardian/Core)
Sound
Siren (Default)
Far
Volume
Alert Delay
1
seconds
Pause Alert Sound
MOB
Connected to
(Guardian only)