ACR Electronics Neo 3 Manual técnico - Página 6

Navegue en línea o descargue pdf Manual técnico para Estufa ACR Electronics Neo 3. ACR Electronics Neo 3 13 páginas. Multifuel

Imprimir página

1. Assembly of the Unit

Operating your stove

Please note that during the first firing,

we recommend a small fire is lit and

that you slowly increase the

temperature to enable the various

parts to expand normally.

You may also experience fumes and a

haze being given off by the stove during

the first firing and possibly for the next

couple of firings as the paint cures. This

is normal but please ensure that the

room is well ventilated during this

period.

The appliance should not be operated in

mild weather with smokeless fuel. Under

certain weather circumstances e.g. fog

the chimney will not draw sufficiently

and could cause asphyxiation.

Await better weather conditions before

attempting to use the appliance.

In the rare event of a malfunction due to

overheating or a chimney fire, the air

control should be shut down completely

and the fuel allowed to burn out. In the

event of a chimney fire, once the air

control has been closed completely, dial

999 for assistance. If the appliance has

overheated, the appliance and flue will

need to be inspected for any damage

before it can be operated again.

Always check with your dealer or directly with the manufacturer as

using the incorrect fuel will invalidate your guarantee and damage your

appliance.

Recommended Fuels

Wood: hardwood such as ash, oak and

beech which have been cut for at least 2

years and stored under shelter. The logs

should have a maximum moisture

content of 20%. Maximum log length

400mm, maximum width 125mm.

Smokeless Fuels: below 20%

Petroleum coke content such as

Anthracite, Phurnacite, Ancit suitable for

use with a closed heating appliance.

Prohibited Fuels

Green wood: i.e wood which is less

than 2 years old with a moisture content

of above 20%

Recovered wood: i.e pallets, railway

sleepers etc. These will have been

chemically treated and will pollute the

atmosphere and possibly overheat the

appliance.

Housecoal or Bituminous coal: these

fuels will soot up the airways of the

stove and possibly overheat the

appliance.

Petroleum Based Coke: over 20% -

this will overheat the appliance and

possibly damage the unit.

Liquid fuels.

Operating your stove

Instructions for use with

wood

• Rotate the air control wheel fully to the

right until the wheel stops, you should

now have the four grooves central to

the appliance door.

• Lay firelighters or rolled up

newspapers on the grate and add a

small amount of kindling wood to the

top. Place 1 or 2 small logs on the top.

• Light the newspaper or firelighters

using a long taper and push the door

to but do not engage the locking

mechanism fully.

• When the fire is burning fiercely, after a

couple of minutes add more logs and

close the door.

• When the fire has become established,

rotate the air control to the left until the

three grooves are central to the door.

• The burning rate can be altered by

rotating the air control wheel between

the three groove and the one groove

setting - rotate the air control towards

the left to decrease the burn rate and

heat output

• Care should be taken to ensure that

the logs are not placed higher than

the log guard allows.

Instructions for use with

smokeless fuel

• Rotate the air control wheel fully to the

right until the wheel stops, you should

now have the four grooves central to

the appliance door.

• Lay firelighters or rolled up

newspapers on the grate and add a

small amount of kindling wood to the

top. Place a small quantity of

smokeless fuel on top

• Light the newspaper or firelighters

using a long taper and push the door

to but do not engage the locking

mechanism fully

• When the fire is burning fiercely, after a

couple of minutes add more

smokeless fuel and close the door.

• When the fire has become established,

rotate the air control to the left until the

three grooves are central to the door.

• The burning rate can be altered by

rotating the air control wheel between

the four groove and the two groove

setting - rotate the air towards the left

to decrease the burn rate and heat

output.

• Care should be taken to ensure that

the firebox is not overfilled with

smokeless fuel - it should be no

higher than the log guard.