ACR Electronics PATHFINDER 3 Manual de soporte del producto - Página 8
Navegue en línea o descargue pdf Manual de soporte del producto para Radio marítima ACR Electronics PATHFINDER 3. ACR Electronics PATHFINDER 3 19 páginas. Search and rescue transponder (sart)
También para ACR Electronics PATHFINDER 3: Manual (20 páginas)
Imprimir página4.0
Life raft stowage
The SART can either be stowed in a life raft or lifeboat or it can be installed next to an
emergency exit for carriage to the life raft in an emergency.
For life raft stowage the SART should be positioned for easy access in an emergency. If
the SART is hidden from view then labels should be used to show its position. For
inflatable life rafts the mounting bracket should be discarded to avoid the risk of
damaging the life raft.
DO NOT...
5.0 Activation
Remove the SART from the bracket.
Activation of the SART is completed by using the three-position switch ring (TEST-OFF-
ON), as shown in figure 4.
1. Turn the Blue activation switch ring to the left, placing the SART in test mode
2. Remove the red Pull Tab by pulling it down and completely out of the SART
3. Release the activation switch and guide it to the right until it is in the ON position
a. The SART will beep once and flash every four seconds
b. The flashing red light indicates the SART is ON
4. Turn the bottom cap of the SART and deploy the telescopic Pole to its maximum
length 3 ft. (1 meter).
5. Remove lanyard and secure it to the life raft.
• Tie Lanyard to vessel
• Cover or obscure SART
• Apply paint to SART
8
Y1-03-0170 Rev. B