AMC MMS-240 Manual de instrucciones de instalación y uso - Página 7

Navegue en línea o descargue pdf Manual de instrucciones de instalación y uso para Amplificador AMC MMS-240. AMC MMS-240 9 páginas. Music sources p. a. amplifier, amplifier with tuner and cd player

Imprimir página

Line Output Connection

This equipment provides two booster output sockets which can be used to drive a booster

amplifier in situations where more power is required. Connection is via RCA phono pluge. (See

above)

Loudspeaker Connection

This equipment provides four different types of loudspeaker output, these are 100V, 70V, 25V line

and low impedance, you can only use one of these output at any one time, any attempt to use two

or more of these may result in damage to the amplifier.

100V Line

These loudspeakers are most commonly used in the Europe for PA distribution. When the

amplifier is at full output 100V RMS will be present at the output terminals. Only use 100V line

loudspeakers with this output. All loudspeakers are wired in parallel and the sum of the power

tapping of each loudspeaker must not exceed the rated output of the amplifier, Ideally, due to the

nature of loudspeaker and transformer impedance's. it is advisable not to load the amplifier to

greater than 70% of its rated output when using music sources.

Zone 1 & 2

In addition to the normal 100V line output there are two sets of 100V line terminals for 2 zones

which can be selected using the push buttons on the front panel

70V / 25V Line

This system is common in the USA, it operates on exactly the same principals as 100V line

except that at rated output the amplifier will have 70V RMS or 25V RMS on its output terminals.

Low Impedance (8 )

This output allows connection of standard low impedance loudspeakers, the minimum load

impedance must be 8 , when two or more loudspeakers are used ensure that they are wired in

such a way that the load impedance is between 8

and 16 .

CD OPERATION

1. Select CD mode with LINE select switch.

2. Press POWER key on CD player

3. Load disc (label side up) into player and PLAY starts automatically.

4. Press PAUSE key and symbol ll appears on the display and play is suspended.

Press pause key to resume play.

5. Pressing

key selects the next track and

key the previous track

6. Press the FOLDER key, FOLDER appears on the display and press the CD previous key or the

CD next key.