Amcor 12000E Manual de instrucciones - Página 9

Navegue en línea o descargue pdf Manual de instrucciones para Aire acondicionado Amcor 12000E. Amcor 12000E 13 páginas. Plm mono blocs
También para Amcor 12000E: Manual del usuario (8 páginas), Manual del usuario (14 páginas)

Imprimir página

• Slide out the filter frame from the unit.

• Separate the filter fixer from the filter frame (see fig. 1).

• Remove the active carbon filter (black) and the 3M Filtrete™ filter (white) from its plastic bag.

• Insert the active carbon filter into the filter frame (see fig. 2).

• Insert the 3M Filtrete™ filter into the filter frame (see fig. 3).

• Fix the filter by reassembling the fixer into the filter frame (see fig. 4).

NOTE!

• Remove the 3M Filtrete™ filter and active carbon filter before seasonal storage and install new filters

at the beginning of the new season. The old filters can be disposed in the 'Non-biological garbage

container' .

• Replacement filter packages are available directly from Amcor.

• To run the unit without active carbon filter and/or 3M Filtrete™ filter does not do any harm to the air

conditioner. In this case odours and unhealthy dust are not removed from the circulated air.

• The screen filter must always be used.

REMOTE CONTROL

The unit responds to all signals that are sent by the remote control. There will be

a beep sound from the unit after receiving the signal.

The operation of the unit by remote control, is almost identical to the operation

by the circular control panel. The only exception is the clock function.

Instead of the

button for setting the actual time and for programming the

timer, there are 3 push buttons on the remote control as follows:

•

- for setting the actual time.

• TIMER ON - for programming the time when the unit is ON.

• TIMER OFF - for programming the time when the unit is OFF.

EMPTYING THE INTERNAL WATER CONTAINER

Under high humidity conditions it may be necessary to empty the internal water container.

When the internal water container is full the backlight on the LCD-display flashes. The unit

will switch off automatically.

To empty the water container do the following:

• Switch off the unit and remove the plug from the wall socket.

Do not move the unit. Doing this can result in water leakage,

damaging your floor or carpet.

• Place the water container on the floor underneath the permanent

drainage point.

• Remove the water stopper and rubber plug from the drain and let the

water run out. The water container has to be emptied several times

before all water will be drained (ca. 1.5 litres).

• Replace the rubber plug and water stopper, put the plug into the wall socket,

and switch the unit on.

The warning signal should be off.

NOTE! When the air conditioner is in use, under normal circumstances the condensed water will

evaporate and then be discharged through the hot air outlet hose