Floe PWC1300 Manual de instrucciones de montaje - Página 12
Navegue en línea o descargue pdf Manual de instrucciones de montaje para Sistemas de elevación Floe PWC1300. Floe PWC1300 12 páginas. Anchoring system
También para Floe PWC1300: Guía de inicio rápido (8 páginas)
Imprimir páginaIF ADDITIONAL ADJUSTMENT IS REQUIRED, LOOSEN 3/8" NUTS AND SLIDE POCKETS
ON FRAME BEAM WITH ANCHOR ASSEMBLIES UNTIL DESIRED POSITION IS FOUND.
ONCE POSITION IS SET, RE-TORQUE NUTS TO 35 FT-LBS (FIGURE 2.9).
DRIVE ANCHOR ASSEMBLY INTO LAKE BOTTOM USING 1-1/8" 6 POINT SOCKET & 1/2" DRIVE
RATCHET UNTIL COLLAR TOUCHES TOP OF ANCHOR POCKET (FIGURE 2.10).
IMPORTANT NOTE:
ONLY USE A 6
POINT SOCKET.
12 POINT SOCKETS
MAY CAUSE
DAMAGE TO HEX
SHAFT.
6 POINT SOCKET
12 POINT SOCKET
DO NOT USE
2X
FIGURE 2.10
SHEET 12 OF 12
IMPORTANT
IMPACT OR
CORDLESS
ANCHORS.
2X
FIGURE 2.9
DO NOT
USE AN
DRILL TO
INSTALL
LIFT