Floe VSD6500 Instrucciones de indemnización - Página 6
Navegue en línea o descargue pdf Instrucciones de indemnización para Sistemas de elevación Floe VSD6500. Floe VSD6500 12 páginas. Full length pontoon & tri-toon bunks large lifts
También para Floe VSD6500: Manual de instrucciones de montaje (8 páginas), Manual de instrucciones de montaje (16 páginas)
Imprimir página
Step 2
Frame beams are fastened to the corner posts
using the pre-attached lower clamps. See corner
post layout in Fig. 2A. Insert frame beam spacers
into ends of all four frame beams before assembly
as shown in Fig. 2B. For ease of assembly, lay the
108" side frame beams between the front and rear
corner posts and fasten to the corner posts using
(4) 1/2" x 4" bolts, (8) flat washers, and (4) nylock
nuts as shown in Fig. 2C&2D. Torque to 80 ft./lbs.
Attach the ball screw clamp to the corner post using
(2) 3/8" x 6" bolts, and (2) nylock nuts, torque to
35 ft./lbs as shown in Fig. 2E. The 109" ball screw
tube is attached using the clamps on the lifting
corner post & the ball screw clamp that was just
installed. Torque to 35 ft./lbs.
Attach the cable end of the tube using, (2) 3/8"
x 6" bolts and (2) nylock nuts. The ball screw
end is attached using, (1) 3/8" x 6" bolt & nylock
nut, & (1) 1/2" x 6" bolt & nylock nut.
IMPORTANT:Make sure to insert bolts thru holes
in bearing block.
Orient the ball screw tube so the large grease
hole is on the side facing out. Pull the cable out
the other end so there are no kinks in the cable.
IMPORTANT: Verify that the lifting cable is
positioned over the top of the ball screw support
bolt before proceeding to the next step! Insert the
coupler end of the ball screw into the hole in the
corner post. Thread the cable from the other end
through the corner post slot and over the sheaves.
Place a 3/8" x 4 1/2" bolt w/ nylock in remaining
hole in lift post clamp. Torque to 35 ft./lbs.
At this time torque the bolts that
were just installed:3/8" bolts to
35 ft/lbs.-1/2" bolts to 80 ft/lbs.
1/2" x 6"
3/8" x 6"
IMPORTANT: INSERT
BOLTS THRU HOLES
IN BEARING BLOCK.
Grease
Hole
Ball screw
supt. bolt
3/8" Nylocks
1/2" Nylock
Fig. 2C
Fig. 2B
SHEET 6 OF 12
3/8" x 4 1/2"
3/8" x 6"
IMPORTANT: THE LIFTING
CABLE MUST GO OVER
THE TOP OF THE UPPER
BOLT IN THE BALL SCREW
CORNER POST CLAMP
Fig. 2D
Fig. 2C
Fig. 2E
1/2 x 4" bolts, flatwashers,
& nylock nuts.
1/2 x 4" bolts, flatwashers,
& nylock nuts.
Fig. 2D