FloEasy Trayless 19961 Manual del usuario - Página 3

Navegue en línea o descargue pdf Manual del usuario para Pulverizador de pintura FloEasy Trayless 19961. FloEasy Trayless 19961 5 páginas.

Imprimir página

PREPARATION FOR USE

Setting up the Paint Roller Assembly

The Paint Roller Assembly is suitable for painting larger areas. Check to make sure foam roller is

inserted fully onto the roller shaft of the Paint Roller Handle. Retainer Clip should be flipped up so the

tab holds the roller in place on the handle. See diagrams below:

Incorrect

Setting up the Accessory Attachments

For painting smaller areas such as trim and moulding, or for painting in confimed

areas, use the Small or Large Paint Pads. For painting into corners, use the Small

or Large Corner Brushes. Set up for all of these is the same.

Accessory attachments are used in conjunction with the Accessory Handle. Insert

desired attachment into end of Accssory Handle, making sure tabs on attachment

align correctly with notches in end of handle. Rotate 1/4 turn clockwise to lock in

place.

Connecting to Hose

Connect either the Paint Roller Assembly or the Accessory Handle to Hose by inserting it into the

hose end, making sure tabs on handle align correctly with notches in hose end. Rotate 1/4 turn

clockwise to lock in place.

Preparing the Paint Container

1. Remove pump assembly from Paint Container by unscrewing the retainer ring located just above

belt clip.

2. Attach Funnel Cup to paint container and fill with paint leaving some space at the top. NOTE: Do

not fill completely or paint will overflow when you place the pump assembly back into container.

3. Place pump assembly back into container and secure in place with the retaining ring.

4. With hose fully uncoiled, hang the Paint Container Assembly on your belt. If you will be painting

with your right hand, place the container on your left side so you can pump with your left hand; if you

will be painting with your left hand, place the container on your right side.

Incorrect

Correct

APPLYING PAINT WITH THE TRAYLESS PAINT SYSTEM

Squeeze the pump handle several times and watch to be sure you see paint flowing through the hose

to the Paint Roller Assembly. (NOTE: If you don't see paint flowing after repeated pumping, check

all hose and attachment connections and be sure there are no kinks in hose.) As the paint begins

seeping out of the roller (or accessory attachment), begin applying to surface. Continue pumping as

needed to keep paint supplied to the roller (or accessory attachment).

Note that the pump handle can be configured to operate at 3 different settings by adjusting the

position of the tabs located on the underside of the handle:

Full Stroke - With both tabs up (parallel with the handle), the pump will operate with a full

stroke and highest volume of paint delivered. This is the optimum setting for the Paint Roller.

1/2 Stroke - With the Small tab rotated to the down position (parallel with the pump shaft), the

pump will operate with a 1/2 stroke, delivering a medium volume of paint. This is the optimum

setting for the Large Paint Pad and Large Corner Brush

1/4 Stroke - With the Large tab rotated to the down position (parallel with the pump shaft), the

pump will operate with 1/4 stroke and the lowest volume of paint will be delivered. This setting

is suitable for the Small Paint Pad and Small Corner Brush.

FULL

1/2

1/4