AMEC CUBO-160 Manual - Página 10

Navegue en línea o descargue pdf Manual para Cables y conectores AMEC CUBO-160. AMEC CUBO-160 19 páginas. Ais splitter

2.2.4 Connecting

After clarifying all definition of port on front panel, users can start install the equipments. The

step of connection shows as follows.

Step 1: Connect the VHF antenna to the label "VHF ANT" Connector

Step 2: Connect the VHF antenna output of VHF Radio to the label "VHF Radio" Connector

Step 3: Connect the VHF antenna output of AIS Transponder/Receiver to the label "AIS TX/RX"

Connector (Notice: Please use UHF Plug – BNC Jack Adaptor to AIS

transponder/receiver if it is necessary)

Step 4: Connect the Antenna Input of AM/FM Receiver to the label "AM/FM" Connector

(Optional)

Step 5: Connect power cable to the label "DC Power"

Step 6: 12~24 VDC power supply to power cable.



The red wire should be connected to the positive power supply connection via 1A rated

fuse or circuit breaker.



The black wire should be connected to the negative supply connection.

Step 2:

Connect VHF Radio

Step 4 (Optional):

Connect AM/FM Radio

Step 5:

Connect Power Cable

Step 6:

Connect 12V ~ 24V

power Supply

AM/FM

Radio

Figure 2-2-3 Wiring definition in Power Cable

Step 1:

Connect VHF Antenna

AIS

VHF

TX/RX

Radio

ANT.

Step 3:

Connect AIS Transponder/Receiver