Coalesse E-table 2 Manual - Página 12

Navegue en línea o descargue pdf Manual para Mobiliario interior Coalesse E-table 2. Coalesse E-table 2 15 páginas.

BE CAREFUL NOT TO DAMAGE THE TOP!

NOTE: Leave gap

Slide top over as

NOTE: Draw Bolts installed

necessary to access

on alternating sides

center Tite Joint holes

11. Install the Tite-Joint™ fasteners on multi-piece table tops (If the table top is one piece, see step 12).

If the top is a multi-piece top, Tite-Joint Fasteners will need to be installed before connecting the top to the

base assembly.

Be certain the set ID numbers on all sections of multiple piece tops are the same.

Carefully remove the protective wood strips from the joining edges of the tabletop sections, prying from the

for installing

underside of the top to loosen. Be very careful not to damage the veneer or laminate when removing these

Tite Joints

strips.

Several installers should carefully lift each section of the tabletop and place them on the base / beam

assembly about 12" off center. Care should be taken to make sure tabletop sections are securely supported

until they can be attached to the base assembly. The sections will need to be spread apart about 12" to

prepare the Tite-Joint Fasteners for assembly.

The Tite-Joint Fastener consists of three parts: the Tightening Nut, the Draw Bolt, and the Locking Sleeve.

Insert the Tightening Nuts into the tabletop halves, alternating halves across the width of the top, with the

threaded ends of the nuts towards the joint. Insert the draw bolts and thread into the nut.

The base/beam assembly will cover some holes. Carefully slide the top half over to one side, balancing it

Draw Bolt

carefully, to access these holes. Install the nuts and bolts, and then re-center the top.

Tightening Nut

Locking Sleeve

After all nuts and draw bolts have been installed, carefully line up the other

table top section with the draw bolts, and slide the halves together.

Page 12 of 15

939500448 Rev E