Aero-Spa Aero-pool Manual de instalación - Página 6

Navegue en línea o descargue pdf Manual de instalación para Bañera de hidromasaje Aero-Spa Aero-pool. Aero-Spa Aero-pool 13 páginas.

Install ballast tube.

1. Remove screw from center section, slide ballast tube onto

bottom of diffuser section with a slight back and forth twisting

motion until the small hole on diffuser section is in the center of

the large hole in ballast tube. Insert screw and tighten until

screw head is flush.

Figure 3: Ballast Installation

2. Connect the free end of the 20' ozone tube to the fitting

exiting the underside of the Aero-Pool unit. Secure with

provided cable tie.

3. Lower the sintered diffuser into the pool in an area that is 7'

deep or less and allow it to rest on the bottom.

4. Locate the closest electrical outlet on the house or garage

that is at least 10' from the pool that can be used to supply

power to the equipment.

5. Insert the electrical plug from the unit into a GFCI (Type 15-

5R) outlet. The equipment will begin to operate. You will hear a

faint hum from the generator and a steady bubble stream will

be emitted from the diffuser.