Aero-Spa AP 1000 Manual de instalación - Página 5

Navegue en línea o descargue pdf Manual de instalación para Dispensador de agua Aero-Spa AP 1000. Aero-Spa AP 1000 12 páginas.
También para Aero-Spa AP 1000: Manual de instalación (13 páginas)

Imprimir página

Equipment Set-up

For best results it is highly recommended that the hot tub be drained

and thoroughly cleaned to remove residual dirt and contaminants

prior to installation of the Aero-Spa™ system. The system should be

cleaned with Aero-Spa™ pipe cleaner and filled with filtered water

through the Aero-Spa™ Fill Filter. The hot tub filter element should be

replaced or cleaned using the Aero-Spa™ filter cleaner.

a) Set the equipment on a

level solid spacer block

that is at least 2 – 3/8"

thick and at least 10'

from the hot tub that is

not prone to flooding

(equipment is weather

proof but not

waterproof) (Figure 2). If

the supplied ozone tube

is not of adequate

length, move the

equipment closer to the

hot tub but not closer

than 10'. Do not extend

or shorten the ozone

tube. If the tube is too

long, coil the excess

tube in an 8" diameter

coil. Note: an

improperly sized

ozone tube will

detrimentally affect the

performance and life of

this product and may void

the warranty!

b) Connect the ozone tube from

the generator to the 20'

ozone tube connected to the

sintered diffuser.

c) Loop the ozone tube over the

edge of the hot tub (figure 3).

Aero-Spa™

NORMAL RESTING SURFACE

Figure 2

Figure 3