Aktobis WDH-310EKW Manual de inicio rápido - Página 10
Navegue en línea o descargue pdf Manual de inicio rápido para Deshumidificador Aktobis WDH-310EKW. Aktobis WDH-310EKW 15 páginas.
También para Aktobis WDH-310EKW: Manual del usuario (20 páginas)
Imprimir página
Instructions for use:
1. Commissioning
1.1 Remove the five (5) supplied and unassembled castors from the condensation tank. Then
lay the dehumidifier on the floor so that the castors can be attached to the bottom of the
unit. Now push the castors in the direction of the arrow (see illustration on the right) into
the devices until they lock into place. Now put the dehumidifier back in place and wait
approx. 30 minutes so that the internal cooling liquid can settle again.
1.2 Insert the mains plug properly into the socket.
1.3 Check that the condensation tank is properly seated in the dehumidifier. (When using the
dehumidifier for the first time, the "condensation tank full" light may come on. Simply pull
the condensation tank out briefly and then push it right back in and you are ready to go).
1.4 Switch on the unit with the operating switch. Now press the humidity setting buttons and
set your target humidity as desired. The target value of 30% humidity actually
corresponds to continuous operation !
The value you set must be below the current room humidity for the unit to dehumidify. If your value is above
the current room humidity, the fan runs for 3 minutes and the unit then switches off. If the room humidity rises
above the set value, the unit automatically starts dehumidifying again.
1.5 Select between low and high fan speed or air circulation with the fan speed button.
1.6 If you want to activate/use the timer function (function for determining the remaining time or function for
specifying a start time), press the TIMER button.
Determining the remaining time: Press the TIMER button during operation to select the desired remaining time
of the dehumidifier. (A value between 1 - 24 hours can be selected using the humidity setting keys). After this
selected operating time has elapsed, the unit switches off automatically.
Determining a start time: When the dehumidifier is switched off, press the TIMER button to select the desired
start time. (A value between 1 - 24 hours can be selected using the humidity setting keys). After this selected
time has elapsed, the unit switches on automatically (with the last settings used, provided the mains plug has
not been disconnected in the meantime).
1.7 If you want to use the control via app, you must first download the "Tuya Smart" app on your smartphone
(tablet) from the app store. After downloading, open the app and make sure that your smartphone is connected
to your Wi-Fi network and that the Bluetooth function of your smartphone is switched on. Now follow the
instructions in the app to register. After registering, click on "Add device" in the app. Select the button
"Dehumidifier" under the category "Small household appliance".
The dehumidifier should now be displayed. Click on it to connect it to your smartphone via the app. As soon as
your smartphone is paired with the dehumidifier, the signal light of the WLAN function in the display stops
flashing and lights up continuously.
Now you can conveniently set the dehumidifier via the app and at the same time read values such as the
current room humidity without having to stand directly in front of the device.
Note: If you do not use the WLAN function for a longer period of time or do not pair the dehumidifier with a WLAN
network, this function switches to standby mode and the signal light stops flashing. To reactivate the WLAN
function, switch off the unit and then press and hold the On/Off button for 5 seconds until you hear a tone
confirming the activation. The unit should now be switched on and the signal light should also flash again. The
WLAN function is active again.
Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
www.AKTOBIS.de
Email: [email protected]