Aktobis WDH-H600A Manual de instrucciones - Página 7

Navegue en línea o descargue pdf Manual de instrucciones para Limpiador de aire Aktobis WDH-H600A. Aktobis WDH-H600A 11 páginas.

3.) The right location

We recommend that you place the air purifier under the following aspects:

 Central to achieving the highest possible effectiveness.

 Near possible sources of dirt (windows, doors, pets, smokers).

 With a minimum distance to the rear of 50 cm and to the top of 40 cm.

 With a distance of approx. 100 cm to TVs, radios and similar devices.

4.) Power connection

First take the power cable and insert the plug into the socket. Now the display panel lights up and the air purifier is

ready for use.

5.) Switching the unit on and off

Press the On/Off button on the control panel of your air purifier to switch your unit on or off.

When the unit has been switched on, it starts its operation in automatic mode by default.

6.) Setting the various operating strengths in manual mode

Press the button to set the air circulation and select your desired power level by pressing it repeatedly. You can

choose between five different strengths (90m³/h at the weakest level and 540m³/h at the highest level).

7.) Air sensor operation (automatic mode)

In addition to the manual setting as explained before in point 6, the air purifier also has an automatic air sensor

mode (automatic mode). Press the selection button for automatic mode. The air sensor mode of the air purifier is

now activated. This is also shown in the display.

If the determined air quality is "good", the air purifier automatically switches to the weak operating strength. If the

result is the opposite and the air quality is inferior or poor, the air purifier switches to a stronger operating strength.

The general air quality and the "pollution" of the air by dust and organic compounds are displayed on the control

and display panel. The display of the air pollution (the PM value) can take on three different colours depending on

the pollution:

PM value < 75 = Blue Value Clean Air

PM value 75 - 150 = Yellow valueLight pollution in the air

PM value > 150 = red value Heavy air pollution

Operating instructions for automatic air sensor operation:

The air sensor reacts to particles in the air and thus always gives only a tendency of the air quality. Since it is a

tendency (similar to a weather station), this function cannot provide a 100% reliable statement about pollutants in

the room air or about the entire area of a room.

Furthermore, stronger operating fluctuations may occur from time to time (jump from good to bad and vice versa),

as the air sensor probe reacts to different particles in the room and is also exposed to draughts.

Note: We recommend that you blow hard into the outer holes of the air sensor at regular intervals to prevent dirt

from accumulating there.

Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany

www.AKTOBIS.de