Aerobar Edge Aerobar Edge Manual del usuario - Página 2
Navegue en línea o descargue pdf Manual del usuario para Pulsómetro Aerobar Edge Aerobar Edge. Aerobar Edge Aerobar Edge 10 páginas. Computerized training and racing device
Imprimir páginaQUICKSTART Instructions (The following provides the summary of the basic steps involved.
For more detailed instructions, please see down below. Thanks!)
Setup Steps
1. Register your account at www.AerobarEdge.com under "My Aerolab"
2. Download the Aerobar Edge app (either iPhone or Android available)
3. Open up your Aerobar Edge app and click "Settings" in the top right corner
4. Click "Registered" button and enter your Username and Password from your desktop
account registration
5. Make sure the bluetooth setting for your phone is ON and push down moderately hard
(about 5-10 lbs of pressure) on the circular pressure sensor to allow phone to detect your
unit
6. Then click "Scan for Device" in your app
7. Once it's found (it will list your device Serial Number), then click the "Register" button
down at the bottom to complete the linkage between your device and the app
8. While not required, it is MUCH easier to download your rides if you link your
Garmin/Timex/Polar/Wahoo or other device to a Strava account. Strava is free and easy to
use, and you can set up your account at www.Strava.com
Using the Aerobar Edge (once the above set-up steps are complete)
1. Install the velcro on the back side of the Aerobar Edge and on a flat, out of the way surface
of your aerobars so it is securely connected to your aerobars. You do NOT need to be able
to see the "aerohead" while riding. In fact, looking for a flashing light in sunshine can be a
significant safety issue so we recommend placing it in a location where you won't be tempted
to look at it when riding.
2. Then, to place the pressure sensor, remove the pad of your aerobar arm rest on the side of
your non-dominant arm (ie, if Right handed, remove the left side) and position the pressure
sensor in the location where your arm pressure will press down on the sensor when riding.
You'll likely need to experiment with this positioning initially to get the best possible
position. Then replace the pad over the top of the sensor.
3. Make sure any excess wire is positioned in such a way that you won't accidentally catch it
with a hand, glove, etc.
4. Open up your Aerobar Edge App (make sure Bluetooth is on) and press on the sensor (hand
or arm is fine - you're just wanting to signal the phone that you've activated the device).
Glance at the LED light to be sure your pressure is activating the sensor.
5. Click upload and allow the app to upload any old or miscellaneous data on the device. You
DO NOT NEED TO CARRY YOUR PHONE WITH YOU when using the Aerobar
Edge. Simply upload shortly before starting and then put your phone away. You will then
upload with your phone after the ride or race has ended.