American Rotary AMP 10 Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Transformador American Rotary AMP 10. American Rotary AMP 10 18 páginas.

1.0 INTRODUCTION

American Rotary specializes in converting single phase electrical power to three phase electrical power . The

three-phase output is delta configured . Most machinery requires a delta three phase voltage and this third

line voltage to ground should not affect operation . If a piece of equipment requires wye voltage and a neutral

connection, the output of the phase converter must be run through a delta-wye transformer to create the

neutral . The phase converter must be started before the transformer is connected electrically . This is done with

a safety disconnect switch . American Rotary can provide these transformers and disconnect switches if needed

by calling 888-743-6832 .

Your AMP phase converter from American Rotary has been designed to be completely plug and play for your

convenience . The AMP has come equipped with the necessary components for easy connection and set-up

(installed features may vary) .

STEP ONE

To connect to your single phase power supply,

use the provided Nema 6-50P single phase plug .

(Customer requires a 208v-240v Nema 6-50R three

prong single phase female receptacle . If you do

not have a receptacle, you can purchase them at

American Rotary by calling 888-743-6832 .)

STEP TWO

Connect the three phase load using the pre-

installed three phase receptacle . (If you do not have

a receptacle, you can purchase them at American

Rotary by calling 888-743-6832 .)

STEP THREE

Turn on the AMP rotary converter by pressing the

START button located on the front of your converter .

This is a magnetic starter intended to start the

rotary phase converter . It is not designed or

intended to be able to start your load . If you do not

have a motor starter for the intended load, one can

be purchased through American Rotary by calling

888-743-6832 . To turn off the converter, use the red

button labeled STOP also located on the front of the

panel . See STARTING AND STOPPING on page 10

for more information .

7 | User Manual R2 .3

STEP FOUR

Place your pre-installed breaker to the on or up

position . This breaker is located above the installed

receptacle .

STEP FIVE

Turn on the power to your load and enjoy having

quality three phase power at your fingertips .