Euro Towers 3T Instrucciones de uso - Página 3

Navegue en línea o descargue pdf Instrucciones de uso para Equipos de construcción Euro Towers 3T. Euro Towers 3T 3 páginas. Klik single width ladder frame tower

Imprimir página

KLIK SINGLE WIDTH LADDER FRAME ERECTION INSTRUCTION MANUAL

The tower requires a minimum of 2 people for assembly; do not attempt to assemble a tower by yourself

Insert two adjustable legs and castors into frames.

rungs pushing from inside to out.

Facing the plain frame, fit a trapdoor platform on

appropriate rung* over the brace hook as near to the

frame vertical as possible, trapdoor to ladder frame

end (*see base set up Fig 1 for guide).

Fit in 2 horizontal braces to the vertical member of

the frames, as low as possible, below the 1st rung.

All horizontal braces fit on from inside the tower

facing out.

Secure stabilizers as soon as possible to increase

tower stability, the lower arm as close to horizontal

as possible.

PLEASE NOTE - If temporary platforms are used during

assembly reposition them during dismantling. Single width

towers have 2 braces at the base and singular thereafter on

alternate sides.

Continue erecting tower to final tower height, repeating steps

8-12.

MOVING A TOWER Remove people and materials from the

tower, and reduce the height of the tower to 4.2m. Adjust and

raise the stabilizers 25mm from the ground, ensure the

couplers are tight, and push from at or near the base by

manual effort only, never use mechanical means. Recheck

level and reposition stabilizers before use.

Braces should be in a continuous pattern from rung to rung

except when interrupted by an intermediate platform.

the rungs pushing from inside to out.

Castor Unlocked

Castor Locked, note

castor wheel has

swivelled in line

The scaffold must be verticle in both planes within

an inclination of 1%

Facing the ladder frame, fit a trapdoor platfonn on

Facing the plain frame fit 1 diagonal to the bottom

rung as close to the right hand frame vertical as

appropriate rung* inside the brace hook as near to

the ladder as possible (*see base set up Fig 1 for

possible. Facing the ladder frame fit 1 diagonal to the

guide).

bottom rung as close to the ladder as possible.

Fit the diagonal braces to continue in a regular pattern

from rung to rung except when interrupted by an

intermediate trapdoor platform.

Dismantling is the reverse of assembly except to

remove guardrail braces. Unclip the far end hooks and

then from a sitting position through the trapdoor (3T)

remove the guardrail braces. Do not remove the

handrails whilst standing on the platfonn; this would

put you at risk.