BobsCNC E3 Manual de inicio rápido

Navegue en línea o descargue pdf Manual de inicio rápido para Herramienta eléctrica BobsCNC E3. BobsCNC E3 3 páginas. Cnc router engraver bearing and rail dust kit
También para BobsCNC E3: Manual de solución de problemas (16 páginas), Manual (8 páginas)

Imprimir página

BobsCNC Evolution E3, E4, E5, and KL series

Thank you for the purchase of the BobsCNC rod and bearing cleaner kit. The following is the instructions to put the

product together. If you don't currently own a wiper kit, they are available from the Old Country Woodworker on Etsy:

Rail and Bearing Wiper Kit

Procedure:

This is a kit for the top bearings and rods for the top X and Y-axis bearing and rods. Each bag is labeled on the bag for

that axis kit.

X-axis' Parts

First thing to do is to thoroughly clean both the rod and bearing on the X-axis of all

dust.

Gather the X-axis bag containing the X-axis parts. The X-axis front bag (photo 1) will

contain, 3 each plywood parts FRX1 FRX3, and FRX4 (Front Right) and FLX1, FLX3 and

FLX4 (Front Left), 1 each FRX2 (Front Right) and FLX2 (Front Left) felt pads, and 4 each

locking washer, flat washer and 4mm X 30mm screws.

The X-Axis Right Rear bag will contain (photo 2), 1 each plywood part RRX1 and RRX3 (Rear Right) and 1 each plywood

part RLX2 and RLX2 (Rear Left), 1 each felt part RRX2 (Rear Right) and RLX2 (Rear Left), 2 cable ties, and 4 each 4mm x

30mm long screws.

Front X-axis' Assembly

We will start on the front right X-Axis bearing and rod. First remove the 2 - 4mm X 16mm screws just above and just

below to the left of the front bearing (see picture 3) and leave the nut in place using masking tape, so they don't fall out

(see photo 4). Keep these screws, since you will use them on the Y-axis

assembly.

Photo 3

4mm screws

to remove

assembly.

CNC Router Engraver

Bearing and Rail Dust Kit

and eBay:

Rail and Bearing Wiper

Get the 2 longer 4mm X 30mm screws from

the rear X-axis kit bag. Place a locking washer

and flat washer on the longer 4 mm X 30mm

screws, then through part FRX1, with the

number facing the head of the screw, then through felt pad part

FRX2, then part FRX3, and FRX4 then insert the screw back into

the frame and into the existing nut. Don't tighten the screws yet until,

the felt parts FRX2 is adjustable. Push the felt pad down until they are

touching the bearing and the rails. When they are touching then

tighten the screws. Photo 5 shows the front X parts mounting on the

Kit.

Page 1 of 3

Photo 1 Front X

Parts

Photo 2

Rear X

Parts

Photo 4