BOC Edwards A531-15-020 Manual de instrucciones - Página 13

Navegue en línea o descargue pdf Manual de instrucciones para Equipamiento industrial BOC Edwards A531-15-020. BOC Edwards A531-15-020 15 páginas.

Imprimir página
3.7
Refit the exhaust trap
Refer to Figure 1 in the following procedure.
1. Move the exhaust trap to its operating location.
2. Inspect the trap outlet trapped 'O' ring seal and clamp (3) removed in Section 3.3. If any item
is damaged, replace it with a new one.
3. Use the trapped 'O' ring and clamp (3) to connect the elbow (2) to the trap outlet.
4. Use the trapped 'O' ring and clamp (6) to connect the pump outlet to the trap inlet elbow (5).
5. Connect the cooling-water inlet hose to the inlet connector (4) on the trap.
6. Connect the cooling-water outlet hose to the outlet connector (7) on the trap.
1.
Small outer liner segment (8 off)
2.
Inner liner
3.
Gap at bottom of inner liner
4.
Long fin on inlet liner segment
5.
Trap inlet position
6.
Large (inlet) liner segment
7.
Large liner segment
12
Figure 4 - Alignment of liners (viewed from the top of the trap)
Disposable Liners