American Standard 1340.825 Instrucciones de instalación

Navegue en línea o descargue pdf Instrucciones de instalación para Mobiliario interior American Standard 1340.825. American Standard 1340.825 4 páginas. American standard metering spread lavatory faucet specification sheet

Imprimir página

METERING

SPREAD LAVATORY

FAUCETS

Thank you for selecting American-Standard...the

benchmark of fine quality for over 100 years.

To ensure that your installation proceeds smoothly--please

read these instructions carefully before you begin.

TOOLS REQUIRED

Tubing Cutter

SPOUT ASSEMBLY

Install RING WASHER (1) into SPOUT (2) recess. Check

that O-RING (3) on end of SPOUT SHANK (4) is in place. Insert

SPOUT SHANK (4) into center hole on mounting surface.

Assemble RUBBER WASHER (5) and BRASS WASHER (6) and

LOCKNUT (7) onto SPOUT SHANK (4). Align SPOUT ASSEMBLY.

From underside of ledge, tighten LOCKNUT (7) to secure SPOUT

ASSEMBLY to mounting surface.

SPOUT RECESS

Installation

Instructions

1340.725

1340.825

1340.855

1340.865

Channel Locks

Turn off hot and cold water

CAUTION

supplies before beginning.

SPOUT

ASSEMBLY

MOUNTING

SURFACE

1340.725

1340.825

Adjustable Wrench

Plumbers' Putty or Caulking

PREPARE TUBE AND TEE ASSEMBLY

Remove COUPLING NUT (1) and FERRULE (2) from each

VALVE (3) and slide onto TUBING (4).

REMOVE HANDLE AND

ACTUATOR ASSEMBLY

Remove HANDLE (1) by

removing INDEX BUTTON (2)

and SET SCREW (3) with a

2.5mm hex wrench.

Pull off HANDLE (1).

Remove ACTUATOR

ASSEMBLY (4).

Remove WASHER (5).

NOTE; Washer (5) may remain

inside of Actuator Assembly.

1340.855

Certified to comply with ANSI A112.18.1M

2.5mm Hex Wrench

MOUNTING

SURFACE

REMOVE

1340.865

968492

REPLACE