American Standard 2823 SERIES Instrucciones de instalación

Navegue en línea o descargue pdf Instrucciones de instalación para Mobiliario interior American Standard 2823 SERIES. American Standard 2823 SERIES 3 páginas. Tissue holder

Imprimir página

TISSUE HOLDER

SOPORTE PARA PAPEL HIGIÉNICO

SUPPORT DE PAPIER TOILETTE

Thank you for selecting American-Standard...the benchmark of fine

quality for over 100 years. To ensure that your installation proceeds smoothly--

please read these instructions carefully before you begin.

Gracias por seleccionar los productos American Standard, sinónimo de la mejor calidad

durante más de 100 años. Por favor lea estas instrucciones detenidamente antes de

comenzar para que lleve a cabo la instalación sin contratiempos.

Nous vous remercions d'avoir choisi American Standard... synonyme de qualité supérieure

depuis plus de 100 ans. Pour vous assurer que l'installation se déroulera sans difficulté,

veuillez lire attentivement ces instructions avant de commencer.

Recommended Tools & Materials/Herramientas y Materiales Recomendados/Outils et matériaux recommandés

10'

Tape Measure

Flexómetro

Ruban à mesurer

INSTALL MOUNTING PLATES

The TISSUE HOLDER (1) works best if secured to a wall stud or cross brace within the wall, using the SCREWS (3) supplied.

If the TISSUE HOLDER (1) is to be installed on a tile or plaster wall the ANCHORS (4) and SCREWS (3) should be used.

Note: The center line distance (6-1/4") between the MOUNTING PLATES (5) is critical, and must be maintained.

Determine desired height and location (optional) and mark a center line. Using the MOUNTING PLATE (5) as a template mark the two

spots for the anchors. If MOUNTING PLATE (5) is secured to a stud or cross brace drill small pilot holes for SCREWS (3).

For installations on drywall, use ANCHORS (4) and SCREWS (3) for securing MOUNTING PLATE (5) to wall. Place #2 Phillips screwdriver

or cordless screwdriver into recess of anchor. Press into drywall while turning the anchor clockwise until it is seated flush with the wall. The

TISSUE HOLDER BODIES (2) are mounted 6-1/4" center to center. Place MOUNTING PLATE (5) over ANCHORS (4) and insert screws

provided with #2 Phillips screwdriver. See illustration below. Repeat above steps for remaining MOUNTING PLATES (5).

For installations on tiled walls, pre drill a 1/4" hole through the tile only. Do not drill into the drywall. Use ANCHORS (4) and

SCREWS (3) for securing MOUNTING PLATE (5) to tiled wall. Place #2 Phillips screwdriver or cordless screwdriver into recess of anchor.

Press into drywall while turning the anchor clockwise until it is seated flush with the tiled wall. The TISSUE HOLDER BODIES (2) are

mounted 6-1/4" center to center. Place MOUNTING PLATE (5) over ANCHORS (4) and insert screws provided with #2 Phillips screwdriver.

See illustration below. Repeat above steps for remaining MOUNTING PLATES (5).

Secure MOUNTING PLATE (5) to wall with SCREWS (3).

6-1/4"

6-1/4" (159 mm)

159 mm (6-1/4 po.)

Installation Instructions

Instrucciones de instalación

Mode d'installation

Drill

Taladro

Perceuse

CENTER LINE

LÍNEA CENTRAL

LIGNE CENTRALE

USE MOUNTING PLATE AS TEMPLATE

USE LA PLACA DE MONTAJE COMO PLANTILLA

UTILISER UNE PLAQUE DE MONTAGE COMME GUIDE

CENTER LINE

LÍNEA CENTRAL

LIGNE CENTRALE

2823 SERIES

SERIE 2823

SÉRIE 2823

Certified to comply with ANSI A112.18.1

Certificación de cumplimiento de la norma ANSI A112.18.1

Certifié conforme à ANSI A112.18.1

U.S. Patent No. D403,750

Patente estadounidense D403,750

Brevet U.S.A. no. D403,750

Regular Screwdriver

Desarmador plano

Tournevis plat

FINISHED WALL

PARED TERMINADA

MUR FINI

M 9 6 8 3 8 5 C

Phillips Screwdriver

Desarmador de cruz

Tournevis cruciforme