American Standard 7460.100 Instrucciones de montaje e instalación - Página 2
Navegue en línea o descargue pdf Instrucciones de montaje e instalación para Mobiliario interior American Standard 7460.100. American Standard 7460.100 4 páginas. Enfield console table with raised wood panels with cast grilles
Imprimir páginaCONSOLE TABLE INSTALLATION
Identify desired location of the console table.
Provide suitable reinforcement required for anchoring the vanity to the wall. Centerline of reinforcement should be 30" up
from the floor (see Figure 1).
Rough in supply lines and waste per rough in dimensions.
Drill at least two 3/8" O.D. anchoring holes through the rear stringer of the console table at 2-1/2" down from the top of
the table (see Figure 2).
Move the vanity into place and level with the adjustable glides on the bottom of the feet. The glides can be adjusted
outward up to 3/8". Anchor it to the wall through the 2 anchoring holes in the rear of the vanity (see Figure 2). Do not
overtighten to prevent cracking the rear stringer.
C/L of 2 x 6
Reinforcement
30"
762mm
FIGURE 1
Finished
Floor
VANITY TOP, SINK, AND FAUCET INSTALLATION
Install the faucet onto the granite top per the manufacturer's instructions.
Two people recommended for this installation
Apply a continuous 1/8" bead of silicone
sealant 1" from the inside edge of the
console. Carefully set the stone top on the
console table. Be sure that the top is
centered on the table.
Use mineral spirits to remove excess silicone from the console and stone top.
FIGURE 2
ADJUSTABLE
GLIDES
(LOCATED
UNDER
EACH FOOT)
- 2 -
19-1/4"
489mm
2-1/2"
64mm
3/8" ANCHORING
HOLES IN
REAR STRINGER
MOLDING
GRANITE TOP
SEALANT
7 5 2 8 7 7 - 1 0 0 R EV. A