American Standard Metering 1340.725 Instrucciones de instalación - Página 2
Navegue en línea o descargue pdf Instrucciones de instalación para Mobiliario interior American Standard Metering 1340.725. American Standard Metering 1340.725 3 páginas. Spread lavatory faucets
También para American Standard Metering 1340.725: Lista de piezas (1 páginas), Instrucciones de instalación (4 páginas)
Imprimir página
3a
VALVE ASSEMBLY (1340.725)
For Cold or Tempered Water Supply
Valve assembly is same as two handle lavatory faucets. See Step 3
instructions for assembly, (1340.725 Single Valve Faucet) is for Cold
or Tempered water only.
5/16'' MIN.
3
4
SPOUT ASSEMBLY
Install RING WASHER (1) into SPOUT (2) recess. Check
that O-RING (3) on end of SPOUT SHANK (4) is in place. Insert
SPOUT SHANK (4) into center hole on mounting surface.
Assemble RUBBER WASHER (5) and BRASS WASHER (6) and
LOCKNUT (7) onto SPOUT SHANK (4). Align SPOUT ASSEMBLY.
From underside of ledge, tighten LOCKNUT (7) approximately
halfway up the spout shank.
Press SPOUT SHANK (4) onto TEE (8) making certain that the
O-RING (3) is properly seated on SHANK (4). Push COUPLING (9)
into TEE (8) and attach to SPOUT SHANK (4) and tighten.
Por la parte inferior, apriete la tuerca (7) para asequrar el
cuerpo a la superficie de montaje.
7
8
4
9
MOUNTING
SURFACE
2
1
Turn off hot and cold water
CAUTION
supplies before beginning.
MOUNTING
9
SURFACE
5
6
1/2" IPS FLEXIBLE SUPPLIES or
3/8" O.D. BULL-NOSE RISER
COUPLING NUT
SPOUT
RECESS
4
HOT
8
9
5
6
7
13
7
8
14
10
4
11
COLD OR
12
TEMPERED
WATER
SPOUT
ASSEMBLY
2
1
3
MOUNTING
SURFACE
COLD
M 9 6 8 4 9 2 R ev. 1. 5