Air Cleaner AC-250pro Manual de instrucciones - Página 6
Navegue en línea o descargue pdf Manual de instrucciones para Limpiador de aire Air Cleaner AC-250pro. Air Cleaner AC-250pro 10 páginas. Uv-c air sterilization
Imprimir página
3. Electromagnetic fields (EMF)
This Air Cleaner device meets all requirements regarding electromagnetic fields (2014/30/EU). Provided this
device is used properly and according to the instructions in this manual, its use is safe according to current
scientific knowledge.
4. Before first use
When the device is delivered, the UV-C tubes which are responsible for the disinfection of the air, are already
inserted. You do not need to take any steps. The device is delivered ready to plug in.
Insert the plug into a 230 Volt socket (applies in CH). You will hear the quiet sound of the air circulation fan
inside the housing. At the inlet, as well as at the outlet you will feel a slight draft. The device is then active and
works reliably.
AT FIRST USE OF THE DEVICE: Until the UVC tubes are equipoised, you will smell a strange odor. This is normal
and can take up to 5 days.
This also applies if the UVC tubes have been exchanged.
5. Using the device
Air Cleaners can be used and set up flexibly and individually. Please make sure that the cable is not a tripping
hazard and a safe stand is guaranteed. Air inlet and outlet openings should have a minimum distance of 50cm
to the next object.
The efficiency of the device depends on the position of the stand and the respective orientation. Place the Air
Cleaner as centrally as possible. The unit sucks aerosols most effectively where they are generated. Please also
consider the general air exchange in the room, such as ventilation systems or open doors that influence the air
flows in the room. Consider the best operating range in a room illustrated in chapter 10.
5.1 Control and monitoring light
PLEASE NOTE: The ECO models with flow regulation have a swith-on delay of up to 15 seconds.
This also applies if a new power level is selected.
As soon as you connect the unit to the mains, the sterilization chamber and the blower switch on
automatically. The control lamp lights up faintly in blue and after 10 to 15 seconds at the latest you will hear
the fan slowly turning up.
The ECO models have a knob on the bottom of the unit with a continuously variable ventilation regulation
function. If you turn the knob all the way to the right, the fan turns to 100% power. Turning the knob to the left
reduces the power.
To switch off the unit, you must unplug the unit from the mains.
6. Housing types & cleaning
Depending on the version of the device, you have one of the following housings: painted, CDF or HPL.
In all cases the housings can be cleaned easily considering the below points:
Painted housing: These housings can be cleaned normally with any universal cleaner.
CDF Housing: These housings can be cleane with a universal cleaer and/or with antibacterial cleaning agents.
HPL Housing: These housings can also be cleaned with chemical cleaning agents and alcohol disinfectant
solutions.
⚠
CAUTION
Please make sure to disconnect the device from the power supply before starting the cleaning/disinfection
process!