16XEIGHT SD2IEC evo2 Manual de instrucciones de instalación - Página 4

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Placa base 16XEIGHT SD2IEC evo2. 16XEIGHT SD2IEC evo2 8 páginas.

1.3

Installation

Switch off your C64 and any attached devices and disconnect it from all cables.

Turn the C64 on its top and remove the three case screws at the front edge. Turn the C64 back

over and open it carefully by lifting the housing to the front edge under the keyboard.

Take care that the locking lugs on the rear side of the case do not break.

Depending on model version, disconnect the keyboard and power LED

from the C64 mother board.

Remove the keyboard and the shielding plate, if necessary, so that after removing the fixing

screws, the exposed motherboard can be removed.

Now, turn the motherboard over and solder

the corresponding three lines of the IEC

supplied connecting cable to the IEC connector

points.

The assignment of the connectors on the C64 and

the SD2IEC are shown in the diagrams and table

on the right:

The cassette port can be used to connect the

power supply line (VCC) and ground line (GND),

as follows:

Double check that the correct connections have been made before refitting the motherboard back

into the case.

Caution:

Ensure the connecting cable is positioned carefully

to avoid creasing and possible damage.

Pin Wire Colour Signal

1 Black

2 Brown

3 Red

4 Orange

5 Yellow

-4-

Ground (GND)

+5V Supply Voltage (VCC)

IEC-ATN

IEC-DATA

IEC-CLOCK

Fig. 1.2

Fig. 1.3