American Standard TOWN SQUARE 2748.XXXX SERIES Instrucciones de instalación - Página 3

Navegue en línea o descargue pdf Instrucciones de instalación para Bañeras American Standard TOWN SQUARE 2748.XXXX SERIES. American Standard TOWN SQUARE 2748.XXXX SERIES 4 páginas. 5' x 42" whirlpool / bathing pool, high gloss acrylic shown less all fittings

Imprimir página

ELECTRICAL INSTALLATION INSTRUCTIONS

All wiring must be performed by a licensed electrician in accordance with the national electrical code and all other

applicable codes.

WARNING:

When using electrical products, basic precautions should always be observed, including the following:

DANGER: RISK OF ELECTRIC SHOCK

Connect only to a circuit protected by a ground-fault circuit interrupter.

Grounding is required. The unit should be installed by a licensed electrician and grounded.

Install to permit access for servicing.

All building materials and wiring should be routed away from the pump body and heater (if equipped).

The whirlpool and air massage versions should be installed on a 120 vac, 15 amp dedicated circuit. The combination

system requires a 120 vac, 20 amp dedicated circuit. The circuit must be a three (3) wire circuit from the electrical

supply panel. A grounded neutral wire and a third wire, earth ground, are essential. ADDING THE SAFE-T-HEATER

REQUIRES A SEPARATE 15 AMP MAXIMUM GFCI CIRCUIT.

ELE CTRICAL I N STA LLATI ON

FOR COM B IN ATI ON SY STE M: S EPA R AT E 20 AM P GFCI OUT LET

FOR WHI RLP OOL OR A IR M AS S A GE: SE PAR AT E 15 A MP GF CI O UTLE T

120 VAC

GND.

753026-100 Rev. H

ELECTRICAL DIAGRAM

READ AND FOLLOW ALL INSTRUCTIONS

WH IR LPO O L MO UNT ED

AI R S WI TCH OR

PUMP/M O TO R

(3)

WA LL TI MER