American Standard Whirlpool/Bathing Pool 2675 Series Instrucciones de instalación - Página 3
Navegue en línea o descargue pdf Instrucciones de instalación para Bañeras American Standard Whirlpool/Bathing Pool 2675 Series. American Standard Whirlpool/Bathing Pool 2675 Series 4 páginas. Whirlpool/bathing pool, high gloss acrylic shown less all fittings
Imprimir página
ELECTRICAL INSTALLATION INSTRUCTIONS
All wiring must be performed by a licensed electrician in accordance with the national electrical code and all other
applicable codes.
WARNING:
When using electrical products, basic precautions should always be observed, including the following:
1. DANGER: RISK OF ELECTRIC SHOCK
Connect only to a circuit protected by a ground-fault circuit interrupter.
2. Grounding is required. The unit should be installed by a licensed electrician and grounded.
3. Install to permit access for servicing.
4. All building materials and wiring should be routed away from the pump body and heater (if equipped).
The whirlpool should be installed on a 120 vac, 15 amp dedicated circuit. The circuit should be hard-wired from the
electrical power supply panel. The circuit must be a three (3) wire circuit from the electrical supply panel. A grounded
neutral wire and a third wire, earth ground, are essential.
E L ECTR ICAL I NS TA L L A TI ON
1 2 0 VA C
G ND.
752445-100 Rev. E
15 A M P
G F C I
OUT LE T
ELECTRICAL DIAGRAM
READ AND FOLLOW ALL INSTRUCTIONS
W HIR L PO OL M OU NT ED
P UM P/ M OT OR
(3)
AI R SW IT CH O R
WA LL T IM ER