Da-Lite Polacoat Da-Plex Semi-Rigid Libro de instrucciones - Página 4
Navegue en línea o descargue pdf Libro de instrucciones para Pantalla de proyección Da-Lite Polacoat Da-Plex Semi-Rigid. Da-Lite Polacoat Da-Plex Semi-Rigid 12 páginas.
Imprimir página
Installation
1. Prepare clean working area and use padded materials or soft,
clean materials in the space where the screen will be
assembled on the floor.
WARNING: The screen surface should be allowed to
acclimate to the temperature and humidity of the location
where it will be installed. Da-Lite does not recommend
beginning installation if there is high humidity in the
room. Care should be taken to prevent water from
condensing on the screen surface as it may leave
permanent marks on the screen surface.
NOTE: Da-Lite recommends that the roll with screen surface
and hardware be removed from the crate and acclimated to
the location at least 48 hours prior to installation.
NOTE: Wear the provided gloves any time the screen surface
is being handled and also during lifting to provide grip.`
4
2. Carefully unpack unit from crate and packaging. Using four
2½"
Figure 1
people, unroll the screen. Locate one person on each end of
the roll with the other two people used as support for the
middle of the roll. Before unrolling the screen, ensure that the
edge/end of the surface is nearest to the floor. While
maintaining slight pressure on the roll, cut each piece of tape
wrapped around the roll at the edge/end of the surface. Once
all tape pieces have been cut, the screen surface can be
unrolled. This should be done gently and in at a measured
pace to prevent damage to the surface. There will be elastic
potential energy stored in the roll. Carefully guide the screen
surface when unrolling, particularly on the last wrap to
prevent the surface from springing out or scraping itself. The
audience side of the screen surface will be face down after it
has been unrolled.
WARNING: Do not step on the screen surface or place
objects on the screen surface during this step or during
installation. This may cause irreparable damage to the
projection coating.
NOTE: Da-Lite recommends that the screen surface remain in
this flat, unrolled state for at least 4 hours prior to Step 9. This
will allow the screen surface to fully adjust to room
temperature and will significantly reduce the risk of breakage
or damage. Do not proceed to assembling the frame on the
screen surface if these precautions have not been taken.