Da-Lite Boardroom ElEctrol Libro de instrucciones - Página 3

Navegue en línea o descargue pdf Libro de instrucciones para Accesorios para proyectores Da-Lite Boardroom ElEctrol. Da-Lite Boardroom ElEctrol 10 páginas. Automatic electric projection screeт
También para Da-Lite Boardroom ElEctrol: Especificaciones (2 páginas), Libro de instrucciones (8 páginas)

Imprimir página

Boardroom Electrol

6. Remove switch assembly (boxed, located at pin end of fabric).

CAUTION! Do not cut wrapping paper or tape with knife or

any sharp tool. Remove by hand.

7. Pull orange string to remove wrapping paper.

8. Install electrical hook up that applies to your unit. Standard

installation is for a single 120VAC or 240VAC wall switch to

control the screen. Optional Control units may have been

ordered. Refer to additional instructions for the external VPI,

external low voltage control and SCB-100. Refer to the

appropriate wiring diagram for your screen.

NOTE: Screen has been internally wired at DA-LITE. Wiring

designated "external" is completed by installer conforming to

local and national codes.

9. Lower picture surface approximately 4"-6" so that the slat will

rest on top of the slat hooks. Guide slat past hooks by gently

pulling fabric forward (Fig. 3). Do not bend hooks.

10. Test installation by carefully running picture surface up and

down 2-3 times. Be prepared to stop screen. Standard Duty

Cycle: 1 MIN. ON / 3 MIN. OFF.

11. Run the picture surface upward. The surface door will

automatically close when the picture surface rolls into the

case. The ends of the slat will catch the two hooks on the

surface door and pull the door closed. When the door closes,

a limit switch is tripped and the motor shuts off.

Installation

CAUTION! Excessive continuous operation may cause

overheating.

12. Run picture surface downward until picture surface

door fully opens.

13. Install junction box cover plate.

14. Close access door and reinstall screws at each end

of access door.

CAUTION! Do not attempt to restore a lost wrap by

adjusting limit switches. Allow one-eighth of an inch (1/8")

clearance around surface door. Make sure door does not

bind. Check hinges. Paint or tile cement will interfere with

free operation. Gravity drops door.

15. Complete installation by painting and finishing to suit

your needs. Finish to allow access door to be removed

if necessary.

Figure 2