American Standard H2Option 2887 Manual de instrucciones de instalación

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Aseos American Standard H2Option 2887. American Standard H2Option 2887 7 páginas.

American Standard H2Option 2887 Manual de instrucciones de instalación
INSTALLATION INSTRUCTIONS
Siphonic Ultra-High Efficiency Two-Piece Toilets
H2Optimum
Single Flush Models 288AA / 288CA / 288DA
H2Option
Dual Flush Models 2886 / 2887 / 2889
®
Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure
this product is installed properly, please read these instructions carefully before you begin. (Certain
installations may require professional help.) Also be sure your installation conforms to local codes.
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
!
NOTE: Pictures may not exactly define contour of china and components.
RECOMMENDED TOOLS AND MATERIALS
Putty Knife
Regular Screwdriver
Hacksaw
Wax Ring/Gasket
1
REMOVE OLD TOILET
a. Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.
b. Disconnect and remove supply line. NOTE: If replacing valve, first shut off main water supply!
c. Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.
d. Remove closet bolts from flange and clean away old wax, putty, etc. from base area.
NOTE: Mounting surface must be clean and level before new toilet is installed!
2
ROUGHING-IN DIMENSIONS:
NOTE: Distance from wall to closet flange centerline must be as listed below:
A = 12" (305mm)
FINISHED WALL
A
FINISHED FLOOR
4
SEALANT
INSTALL WAX SEAL
Invert toilet on floor (cushion to prevent damage),
and install wax ring evenly around waste flange
(horn), with tapered end of ring facing toilet. Apply
a thin bead of sealant around toilet base.
Product names listed herein are trademarks of AS America Inc.
© AS America Inc. 2016
Adjustable Wrench
Flexible Supply Tube
SUPPLY
AS
REQ'D.
5
WAX RING
POSITION TOILET ON FLANGE
a. Unplug floor waste opening and install toilet on closet flange so bolts project
through mounting holes.
b. Loosely install retainer washers and nuts. Side of washers marked "THIS
SIDE UP" must face up!
Sealant
Closet Bolts
3
CLOSET
FLANGE
CLOSET
BOLTS
INSTALL CLOSET BOLTS
Install closet bolts in flange channel
and slide into place parallel to wall.
CLOSET
BOLT
FLANGE
Certified by
IAPMO R&T
Tape Measure
Carpenters Level
A
NUT
TAPERED
WASHER
7301416-100 Rev. L 1 /16