American Standard QUEST 2007.101 Instrucciones de instalación - Página 2
Navegue en línea o descargue pdf Instrucciones de instalación para Cocina & Accesorios de baño American Standard QUEST 2007.101. American Standard QUEST 2007.101 4 páginas. Monoblock bathroom sink faucet with conventional pop-up drain
Imprimir página
2
INSTALL POP-UP DRAIN
Fig.1
Apply a bead of putty to underside
of FLANGE (1).
Fig.2
Drop FLANGE (1) into LAVATORY DRAIN (2).
From below assemble RUBBER GASKET (3), METAL
WASHER (4) and LOCK NUT (5). Do not tighten.
Fig.3
Place SEAL (6) with small end facing up into
TAILPIECE (7) and tighten against DRAIN BODY (8).
PIVOT ROD (9) opening in TAILPIECE (7) should face
the rear of the lavatory.
Tighten LOCK NUT (10) with channel locks.
Do not over tighten.
3
ASSEMBLE PIVOT ROD TO POP-UP DRAIN
Assemble PIVOT ROD (1), PIVOT NUT (2), CLIP (3) and SEAL (4) as
shown. Hand tighten PIVOT NUT (2). Drop STOPPER (5) into drain.
(For vandal proof drain rotate stopper so PIVOT ROD (1) goes
through EYE (6) of STOPPER (5). Make connection to "P" TRAP .)
Remove one end of CLIP (3) from PIVOT ROD (1) by squeezing
ends together while sliding.
Insert PIVOT ROD (1) into second or third hole in EXTENSION (7)
and reassemble CLIP (3). (EXTENSION (7) may need to be bent).
Adjust STOPPER (5) height by repositioning EXTENSION (7) and
tightening THUMBSCREW (8).
Fig.1
1
PUTTY
Fig.3
8
9
8
7
3
Fig.2
3
10
6
7
5
1
2
4
1-1/4" OD
TAILPIECE
"P" TRAP
1
2
4
5
6
M965256 REV. 1.4