American Time SiteSynq IQ Manual de instalación y funcionamiento - Página 8
Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Reloj American Time SiteSynq IQ. American Time SiteSynq IQ 19 páginas. Wireless digital clocks
Imprimir página
Digital Clock Operation
Powering Up
Apply power to the digital clock. The firmware version number will appear for a few seconds, followed by all digits
illuminated. It will then scroll a digit pattern while it looks for the correct time from the SiteSync IQ system controller.
Once the receiver inside the clock gets a signal, the clock will begin keeping time. At first startup, the clock may display
a time such as 1:00:00 until it receives the first time update from the SiteSync IQ system controller. This should only
take a few seconds, after which the correct time from the SiteSync IQ system controller should appear.
Setting Time
Setting of the time is not needed for the digital clock or timer control station. The time information is automatically
updated by the SiteSync IQ system controller. The 12- or 24-hour mode option can be configured by the display
settings of the system controller, or by the push buttons on top of the clock (see Setting 12 or 24 Hr Mode on pg 11).
The ATSTCS timer control station will allow the user to set a 12- or 24-hour mode and time when the SET/RUN switch
is in the SET position. However, the time and the 12- or 24-hour format will be overridden by the SiteSync IQ system
controller when it updates the time. Set the SET/RUN switch to the RUN position and the UP/DOWN/CLOCK switch
to the CLOCK position to return the clock display.
Setting the Up Counter Preset Time (optional)
If you want to use the alarm and hold feature with the UP timer, you will need to set a preset time for the UP timer.
Set the UP/DOWN/CLOCK switch to the UP position.
Set the SET/RUN switch to the SET position. The hours digits will be flashing.
Using the INCREMENT switch, set the desired hours for the preset time, then press ENTER. The minutes digits will
now be flashing.
Set the desired minutes the same way, then press ENTER. The seconds digits will then be flashing.
Set the desired seconds the same way, then press ENTER. The display will then flash
Set the SET/RUN switch back to the RUN position.
n Note: A preset of 00:00:00 allows the digital clock/timer to be used as a standard elapsed timer with a maximum
elapsed time of 30:59:59.
8
Wireless Digital Clocks Owner's Manual
Wireless Digital Clocks Owner's Manual
.
donE
© American Time
© American Time