Dongcheng DMY02-235 Manual de instrucciones - Página 7
Navegue en línea o descargue pdf Manual de instrucciones para Sierra Dongcheng DMY02-235. Dongcheng DMY02-235 10 páginas. Electric circular saw
Imprimir página
Sighting
For straight cuts, align the right notch on the
front of the base with the cutting line on the
workpiece. For 45° bevel cuts, align the left
notch with it. (Fig. 11)
Switch Action
CAUTION:
Before plugging in the tool, always check to
see that the switch trigger actuates
properly and returns to the "OFF" position
when released.
To start the tool, simply pull the switch trigger.
Release the switch trigger to stop. (Fig. 12)
Removing or Installing Saw Blade
CAUTION:
Always be sure that the tool is switched off and unplugged before installing or
removing the saw blade.
Do not use saw blades which do not comply with the characteristics specified in
these instructions.
Do not use saw blades the disc of which is thicker or the set of which is smaller than
the thickness of the riving knife.
Be sure the blade is installed with teeth pointing forward in the same direction as the
tool rotation (the arrow on the blade should point in the same direction as the arrow
on the tool).
Never depress the spindle lock while the saw is running.
Use only original wrench to remove or install the blade.
The following blade can be used with this tool:
-11-
Max. Dia.
235 mm
The thickness of the riving knife is 1.6 mm.
To remove the blade, press the spindle lock so
that the blade cannot revolve and use the hex
wrench to loosen the hex socket head bolt
counterclockwise. (Fig. 13)
Then remove the hex socket head bolt, outer
flange, raise the lower safety guard as much as
possible, and remove the saw blade. (Fig. 14)
To install the saw blade, follow the removal
procedures in reverse. Install the inner flange,
saw blade, outer flange and hex socket head bolt,
in that order. (Fig. 15)
Be sure to secure the hex socket head bolt
clockwise tightly with the spindle lock fully depressed.
When changing blade, make sure to also clean upper and lower blade guards of
accumulated sawdust. Such efforts do not, however, replace the need to check
lower guard operation before each use.
Min. Dia.
230 mm
-12-