American Time PE55LGPD304 Manual de instalación de inicio rápido - Página 2

Navegue en línea o descargue pdf Manual de instalación de inicio rápido para Relojes de fichar American Time PE55LGPD304. American Time PE55LGPD304 2 páginas. Power over ethernet (poe) analog clocks

Imprimir página
QUICK START INSTALLATION GUIDE
4
Set up the Clock
1.
Apply power to the clock by connecting a CAT 5 or higher Ethernet patch cable
a PoE switch (Fig. 1) or single injector (Fig. 2) to the PoE receiver (D).
—PoE Switch (Fig.1) - Check with network administrator for infrastructure needs. This part
is not supplied by American Time.
—PoE Injector (TMA200-6) (Fig. 2) - This is an optional power source that may be
purchased from American Time.
2.
The Status LED
(B)
will indicate the clock's status as follows:
—Flashing Orange: Acquiring an IP address using DHCP
—Flashing Red: Attempting SNTP sync
—Continuous Red: Failed SNTP sync
—Flashing Green: Received SNTP sync
—Continuous Green: Successful SNTP sync
Note: When a DHCP network is not present at initial start up, the PoE clock will default
to a random Static IP in the range of 169.254.1.0 to 169.254.254.255.
For more details reference the PoE Analog and Global Series Digital Manual.
Find it online:
american-time.com
Navigate to:
SUPPORT > PRODUCT DOCUMENTATION > select MANUAL > type PoE in
searchbox > SEARCH
– Click on PoE Analog and Global Series Digital Manual.
3.
The Buzzer LED
(C)
designates if the buzzer is enabled. The buzzer is an optional feature.
Ethernet
Gigabit Switch
Power
Fault
Locator
B
D
C
A
A=PoE connection
(CAT 5 or higher Ethernet patch cable)
10/100/1000 Base-T Ports (1-24)
1
3
5
7
9
11
13
15
17
19
21
23
Act
LED
Mode
FDx
Spd
Reset
Clear
2
4
6
8
10
12
14
16
18
20
22
24
PoE switch
A
Fig. 1
TMA200
A
Fig. 2
B=Status LED C=Buzzer LED D=PoE Receiver
POWER OVER ETHERNET ANALOG CLOCKS
5
Adjustments via Network Clock Connect
(A)
from
1.
Download Network Clock Connect. Find it online:
Navigate to:
Click on Network Clock Connect.
The software will automatically download. It is also available from the optional USB
Drive (H004167B-POE, purchased separately).
2.
Install Network Clock Connect application – Password = clock4u (default)
3.
Network Clock Connect will allow you to configure:
• Network address settings
• Time Synchronization settings
• Daylight Saving Time settings
• Schedules (Buzzer clocks) - maximum of 100 scheduled events
For more details, reference the PoE Analog and Global Series Digital Manual.
american-time.com
SUPPORT > PRODUCT DOCUMENTATION > select FIRMWARE > SEARCH