Donjoy ISOFORM LO+ Instrucciones para la solicitud

Navegue en línea o descargue pdf Instrucciones para la solicitud para Equipamiento médico Donjoy ISOFORM LO+. Donjoy ISOFORM LO+ 2 páginas.

Imprimir página

BEFORE USING THE DEVICE, PLEASE READ THE INSTRUCTIONS FOR USE COMPLETELY AND CAREFULLY. CORRECT APPLICATION IS VITAL TO THE PROPER FUNCTIONING OF THE DEVICE.

SIZING:

Size the Brace

Begin by measuring the circumference of the patient approximately 2.5 cm (1") above the widest part of

the hips. Then, match the patient's size to the sizing chart below. If patient's circumferential

measurement is between sizes, select the larger brace.

SIZE

S/M

L/XL

NOTE:

It is not uncommon for the patient to experience post-surgical swelling, followed by weight

loss (4.5 - 9.1 kg/10 - 20+ lbs). The LO+ brace is designed with two (2) adjustable belts which can be

easily sized to achieve optimal fit.

FITTING:

Adjust Circumference

To adjust waist belt circumference, align the tip of the hook and loop attachment on the rear panel

section with the correct circumference. Repeat for opposite side. (Fig. A) For patients whose

circumferential measurement is between 152 and 178 cm (60 and 70"), use optional bridge

wing (sold separately). Apply hook portion of donning mitt to the loop exterior.

APPLICATION:

Step 1. Loosen the Brace

Loosen the brace by detaching the pull tab from the loop exterior. Pull the belt wings in opposite

directions. (Fig. B)

Step 2. Position the Brace

Center the rear section of the belt at the midline of the lower back, so that the belt is just above

the crease of the buttocks. Note: The brace is intended to be worn over clothing.

Step 3. Secure the Brace

Secure the hook portion of the donning mitt to the loop exterior. (Fig. C) Before tightening the brace,

make sure the rear panel section is positioned evenly on both sides of the patient. Have the patient

slip their thumbs through the holes in the pull tabs and pull the tabs away from the body.

NOTE FOR OPTIMAL WAIST FIT: The belt wings may be secured to the rear panel section at an

angle to accommodate a size differential between the waist and hips. (Fig. D) When tightened,

secure the pull tabs to the loop exterior. (Fig. E)

Helpful Tip: Brace Migration

To reduce brace migration, follow these easy steps. Before sitting, loosen the brace by detaching the

pull tabs. Once seated, tighten the pull tabs by pulling across the body and re-adhering to the loop

exterior. When standing up, readjust pull tabs.

Brace Removal

To remove the brace, first loosen it by detaching the pull tab from the loop exterior. Then unhook the

donning mitt from the loop exterior and take off the brace.

Brace Re-Application

When reapplying the brace, it is easiest to guide the belt by inserting a hand in the donning mitt pocket.

DonJoy

Clinician Application Instructions

CIRCUMFERENTIAL MEASUREMENT

71-122 cm (28-48")

122-152 cm (48-60")

ISOFORM

™

LO+