Astonica 50101040 Manual de instrucciones - Página 2
Navegue en línea o descargue pdf Manual de instrucciones para Mobiliario interior Astonica 50101040. Astonica 50101040 2 páginas. Orchid inlay arch-back garden bench
Imprimir página
PARTS & HARDWARE LIST
PART #
DESCRIPTION
A
Arched Bench Back
B
Wood Seat Slats
C
Cast Iron Legs & Arm Brace
D
Middle Support Bracket
E
Side Support Brackets
6mm x 32mm Bolt
F
6mm Washer
G
6mm Nut
H
Phillips Wood Screw
I
J
Plastic Nut Cover
A
B
D
E
F
G
Carefully remove the contents from the package.
If any parts are missing do not attempt to use the product until
they have been obtained and correctly installed.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-888-422-7800.
Caution: Do not over tighten fasteners.
QUANTITY
1
5
2
1
2
16
16
16
7
4
C
E
H
I
ASSEMBLY INSTRUCTIONS
1. (SEE FIGURE 1) Using Bolts (E) washers (F)
and nuts (G) attach one end of the Arched
Bench Back (A) to the Cast Iron Leg (C).
Attached the other end of the back to the
second leg & arm brace (C).
2. (SEE FIGURE 2) Attach the wood slats (B)
to the arm and leg support (C) as shown.
Repeat on the other side and do not tighten
bolts until all wood slats (B) are in place and
bench is at 90 degrees with floor.
3. (SEE FIGURE 3) Turn the bench over on a
non-scratch surface and attach middle
support bracket (D) to the slats (B) at the
midway point between legs (C) using wood
screws (H). Work from the top to bottom,
bending bracket (D) as necessary to fit the
contour of the bench.
4. Ensure all fasteners are securely tightened.
5. (SEE FIGURE 4) Attach the side brackets (E)
to the leg & arm braces (C) using bolts (F)
washers (G) and nuts (H). Align the other
end of brackets (E) with the center of a wood
slat and fasten with wood screws (I).
6. Ensure all fasteners are securely tightened.
F
FIGURE 1
J
H
G
A
C
G H J
F
FIGURE 2
C
B
F
F
G
H
FIGURE 3
H
D
FIGURE 4
I
G
H
E
F
C