Astonica 50104264 Manual de instrucciones - Página 2

Navegue en línea o descargue pdf Manual de instrucciones para Mobiliario interior Astonica 50104264. Astonica 50104264 2 páginas. Junior tortoise bench

Imprimir página
PARTS & HARDWARE LIST
PART #
DESCRIPTION
A
Straight Back
B
Wood Seat Slats
C
Right Leg & Arm Frame
D
Left Leg & Arm Frame
E
Middle Seat Brace
F
6mm x 32mm Bolt
G
6mm x 30mm Bolt
H
6mm Washer
I
6mm Nut
J
Screw 4mm x 16mm
K
Plastic Nut Cover
Parts Detail
A
B
E
F
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
NOTE: This product is intended for residential, non-commercial use.
CAUTION: Do not over tighten fasteners.
1. (SEE FIGURE 1) Using bolts (F), washers (H)
and nuts (I) attach one end of the straight
bench back (A) to the right leg & arm brace (C).
Attach the other end of the back to the
left leg & arm brace (D) using the same bolts,
washers and nuts.
QUANTITY
1
4
1
1
1
4
4
6
6
4
4
C
D
J
I
H
G
A
Figure 1
F
H
I
H
I
C
1
2. (SEE FIGURE 2) Attach the wood slats (B)
to left leg and arm frame (D) with bolts (G),
washers (H) and nuts (I). Repeat on the right
leg and arm frame, but do not tighten bolts
until all wood slats (B) are in place and bench
is upright on the floor.
3. Ensure all fasteners are securely tightened.
4. (SEE FIGURE 3) Turn the bench over on a
non-scratch surface and attach middle
support bracket (E) to the slats (B) at the
midway point between legs and arm frames
using screws (J). Work from the front to back,
bending bracket (E) as necessary to fit the
contour of the slat seat.
5. Ensure all fasteners are securely tightened.
K
6. (SEE FIGURE 4) Add plastic nut covers (K)
to nuts (I) located on backside of straight
back (A).
D
ASSEMBLY INSTRUCTIONS
Figure 2
C
Figure 3
Figure 4
2
G
D
H
I
B
J
E
B
(I) Plastic Nut Cover
Four places backside