Astonica 50105436 Manual de instrucciones - Página 2

Navegue en línea o descargue pdf Manual de instrucciones para Mobiliario interior Astonica 50105436. Astonica 50105436 2 páginas. 48'' round table

PARTS LIST

PART #

Table Top

Table Leg

Leg Connector Ring

Bumper

Bolt

Plastic Umbrella Cap

Carefully remove the contents from the package. If any parts are missing do not

attempt to use the product until they have been obtained and correctly installed.

IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,

DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT

1-888-424-3354

NOTE: This product is intended for residential, non-commercial use.

DESCRIPTION

QUANTITY

1. (SEE FIGURE 1) Insert bumper (D) into

previously drilled holes at top of each leg (B).

CAUTION: Do not place table top on a hard

surface during assembly. Possible damage

to table top can occur.

2. (SEE FIGURE 2) Place table top (A) upside

down on a flat non-scratch surface.

3. With bumper (D) installed, slide each leg (B)

into end cap leg fittings as show in diagram.

NOTE: Make sure bumper (D) on the leg stays

in place between leg and glass top.

4. Place leg connector ring (C) between legs and

loosely attach ring using bolts (E).

5. Check alignment of all legs, and correct,

if necessary before tightening bolts.

6. Gradually tighten all bolts, moving from one

leg, then the next until all legs firmly attached.

7. Place table right side up and install plastic

umbrella cap inside center hole of table.

ASSEMBLY INSTRUCTIONS

Figure 2

Figure 1