AmeriGlide RUBEX Manual de instalación - Página 12
Navegue en línea o descargue pdf Manual de instalación para Sistemas de elevación AmeriGlide RUBEX. AmeriGlide RUBEX 16 páginas.
También para AmeriGlide RUBEX: Manual del usuario (8 páginas)
Imprimir páginaINSTALLING THE POWER CORD
For AC Powered Lifts: Locate the power cable
and plug into the side of the upper track cover.
The green light should light up - indicating the
unit is receiving power. If not, check the circuit
breaker under the green light.
For DC Powered Lifts: The batteries need to be
connected prior to the unit being installed. To do
this, connect the negative wire (black wire) to
the battery next to the motor on top of the unit.
The charger must be plugged into 115 VAC
grounded outlet, and left plugged in all the time
for the batteries to properly charge. The Owners
Manual has a page that describes the lights that
show on the charger.
Caution!
Do not ride.Track brackets are not yet completely anchored.
INSTALLING THE LOWER LIMIT CAM
Step 1: The upper and lower limit cams are safety devices
that automatically stop the unit at each landing. They are
on opposite sides of the track to hold the unit in place
during shipping.
Step 2: Locate the lower limit cam (on the track under
the unit) and move to the bottom of the track - butting it
against the bottom track cover and tighten into place.
NOTE: Before the upper limit cam can be moved to its
proper position, the seat will have to be attached to
the unit chassis.
Rubex Stair Lift Install Manual | www.Ameriglide.com | 866-378-6648
12 //
16
Call / Send
plugs
AC Plug
AC Powered Header
Call / Send
plugs
DC Plug
DC Powered Header
Green light not supplied on
DC powered lifts
11819 P/N: 16169 Rev D