DoorHan SHAFT-120 Manual de instalación y funcionamiento - Página 8

Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Sistema de apertura de puertas DoorHan SHAFT-120. DoorHan SHAFT-120 12 páginas.
También para DoorHan SHAFT-120: Manual de instalación y funcionamiento (12 páginas)

Imprimir página
ADJUSTMENT OF OPEN AND CLOSE POSITIONS
Fine adjustment
Turning screw for fine adjustment, correct the close position of the gate.
•
Open and close the gate, make sure, that red cams push the micro-switches and the gate remains in the desired position.
•
Clockwise turn of the screw causes earlier actuation of the end switch, counter-clockwise turn of the screw causes later actuation
respectively.
•
Open and close the gate, make sure, that red cams push the micro-switch and the gate remains in the required position.

10.2 Open position (blue cam)

Coarse adjustment
•
Make sure, that the operator is fixed rigidly; put the gate in completely closed position.
•
Loosen the screws for coarse adjustment of blue cam, then turn them so, that the micro-switches are pushed, then tighten the screws.
•
Close and open the gate, make sure, that the blue cams push the micro-switch and the indicator DL2 on the control unit is out.
Fine adjustment
•
Turning the fine adjustment screw, correct the closed position of the gate.
•
Clockwise turning of the screw causes earlier actuation of the end switch; counter-clockwise turning of the screw causes later actuation
of the end switch.
•
Open and close the gate, make sure, that the blue cams push micro-switch and the gate remains in the required position.
Notes:
•
When the end positions are adjusted, make sure, that the end switches are operable: after pushing of the cam the relative
indicator on the control unit shall dim out.
•
If the indicator does not dim out, repeat adjustment.
Closing end switch cams (red)
Note:
•
When the end positions have been adjusted, make sure, that the end switches are operable: by pushing the cam the relative
indicator on the control unit shall be out.
•
If the indicator is not out, repeat adjustment.
8
O PERATO R S HA F T-1 2 0 I N STA L L AT IO N AND O PE RAT ING MANU AL
Opening end switch cams (green)
Fine adjustment screw
Additional cam
Fixing screw