DoorHan PCB-SW Manual de instrucciones de programación - Página 19
Navegue en línea o descargue pdf Manual de instrucciones de programación para Control Panel DoorHan PCB-SW. DoorHan PCB-SW 20 páginas. Control board
También para DoorHan PCB-SW: Manual de instrucciones de programación (20 páginas)
Imprimir página
3. TRANSMITTER PROGRAMMING
3.1. RECEIVER MEMORY CLEARING
After power is on press and hold the «R» button for 20 seconds. A long audio signal will be heard and the program will be
activated.
3.2. RECORDING OF TRANSMITTERS IN THE RECEIVER
To record the transmitter press and hold the «R» button till the display will show double zero «00». Then press twice the but-
ton on the transmitter that you wish to control the control unit. A short click will be heard meaning the code has been success-
fully programmed. The display will show the number of recorded transmitters. Wait for automatic switching to operation mode.
To record several transmitters repeat the code recording procedure for every transmitter. Thus, up to 100 transmitters can be
recorded in the receiver memory.
NOTES:
Multichannel transmitters can be recorded too making it possible to separately control gate opening and closing.
If no control commands are given during 20 sec the unit exits the transmitter recording mode automatically.
If the control unit is disconnected from the power supply the data programmed are saved in the memory.
In case of receiver memory overflow 3 long audio signals will be given.
3.3. REMOTE PROGRAMMING OF DOORHAN TRANSMITTERS
Perform items 1-4 within 5 seconds interval:
1. Press and hold the button 2 of programmed transmitter (see the figure below).
2. Holding the button 2 pressed, press and hold the button 1.
3. Release all the buttons.
4. Press the programmed transmitter button, the receiver will switch to the transmitter programming mode.
5. Press twice the button on new transmitter that you wish to control the operator.
A short click will be heard meaning the code has been successfully programmed. The display will show the number of re-
corded transmitters (for example, «01»).
1
4
3
2
NOTES:
Perform the transmitters programming within the operation range of the electric drive receiver.
Number of each button can be determined by the dots on the transmitter body.
Two memory cells are used when recording multi-channel remotes T5 PRO/T15PRO.
1
1
3
4
2
2
TRANSMITTER PROGRAMMING
1
2
19