dacell AM-1000 Manual del usuario - Página 9

Navegue en línea o descargue pdf Manual del usuario para Amplificador dacell AM-1000. dacell AM-1000 18 páginas. Dynamic strain amplifier

Imprimir página
It is the switch to control GAIN and it can be controlled as in X1, X10, X100,
X400, X1000 times.
○
GAIN control volume
12
It is a volume to control GAIN and it can be continuously controlled as in 을
from X1 up to X11 times.
○
GAIN fine control volume
13
It is a volume for the fine control of GAIN. It can be continuously controlled
as in from X1 up to X2 times.
○
Power lamp
14
This lamp shows you the power supply to Amplifier.
○
Power switch
15
This switch is to supply power to Amplifier.
○
Sensor input voltage monitor terminal
16
This can monitor Sensor input voltage
○
Sensor output voltage monitor terminal
17
This can monitor Sensor output voltage
○
Signal output monitor terminal
18
This can monitor output voltage of Amplifier.
○
Low-current output (more than 2kΩ load) connector
19
It is the final output signal of Amplifier and also low-current output.
You can use this more than 2kΩ load.
○
High-current output (more than 200 Ω load) connector
20
It is the final output signal of Amplifier and also high-current output.
You can use this on more than 200Ω load.
○
Sensor input connector (MS connector)
21
You can use Full bridge, Half bridge, Quarter bridge and Potentiometer
Voltage input ,etc
○
Case earth terminal
22
Connects and uses with outside ground in case of biographical environment
with noise is bad.
○
Fuse
23
It is a fuse to protect from outside excess current. AC 220V 0.5A)
8