Air Fantastic CAP5000 Manual del usuario - Página 10

Navegue en línea o descargue pdf Manual del usuario para Limpiador de aire Air Fantastic CAP5000. Air Fantastic CAP5000 16 páginas. Central air purifier (cap)

Imprimir página

3. A trained service professional should be

consulted to determine the extent of rota-

tion. Rotate the UV Shield to the desired

opened or closed position. Place one

hand on the Distal Cap and the other on

the Outer UV Shield. Rotate the Distal

Cap clockwise while rotating the Shield

counter clockwise until the desired posi-

tion is reached. Rotation will require firm

pressure.

Note: The CAP unit is designed to re-

quire firm pressure during rotation. Never

rotate the Ballast Cover and Distal Cap

simultaneously in opposite directions.

Doing so could possibly disassemble the

unit and void the warranty.

Be sure to insert the

Quad-Ion lamp with the

opening facing the air

flow.

Note that the CAP System should be orientated with the "air flow" label run-

ning parallel with the length of the duct to ensure the four pins are in line with

the Four Pin Connector. Before inserting the CAP System, use a 1/4" hex

head screw driver to remove the four outer screws and pull off the Ballast

Assembly from the Retainer Ring. Remove the wax paper from the gasket

located on the bottom side of the Retainer Ring. Insert the Retainer Ring with

the Quad-Ion Lamp attached into the 4" hole, aligning the cross hairs parallel

to the duct. Press firmly on the Retainer Ring to adhere the gasket to the duct.

Place Aluminum Tape Ring over Retainer Ring aligning the center. Firmly

press the Ballast Assembly onto the four pins protruding from the Quad-Ion

Cell Optional mounting configurations, such as opening the UV shields, may

vary the orientation of the "air flow" label. It's only intended to serve as a gen-

eral guideline.

Retainer Ring

Cross Hairs

Ballast Cover

Outer UV Shield

Duct

Quad-Ion Cell

Cross Hairs

Air Flow Label

Distal Cap

Pin Orientation

Ballast Assembly