Akw AKW91182L Manual de instalación y uso - Página 8

Navegue en línea o descargue pdf Manual de instalación y uso para Productos de fontanería Akw AKW91182L. Akw AKW91182L 12 páginas. Shower screens

Installation

12. Waterproof Seal

On the outside of the screen, apply silicone sealant along the bottom of the compensator or

corner block (for wet floors) and along the bottom of the fixed panel.

On the inside of the screen, apply silicone sealant up the side of the compensator. In general,

Horizontally on the Outside, Vertically on the Inside.

13. Positioning the Magnetic Closing Strip

Place the magnetic closing strip on the inside of the outer door in roughly the right position.

Bring the doors almost to a close to verify the position of the closing strip. Once its position

is set, drill 3 mm pilot holes into the rails through the hole in the part at each end. Remove the

backing paper from the double sided tape and firmly press the strip onto the panel. Fasten the

closing strip to the door using 3.5 x 16 mm countersunk screws (no.6 x ⅝").

F ig. 16

Ensure that the closing strip

Ensure that magnet and adaptor are

is correctly positioned

correctly positioned

Fig. 12.0 and 12.1

Fig. 13.0, 13.1 and 13.2

3 mm

3.0mm

diameter

holes

F ig. 17

Tray Installation

Wet Floor Installation

backing

no.6 x ⅝" csk

No.6 x

" csk

F ig. 18

General: 01905 823 298

doublesided

tape