Flycam FLCM-DN-ABQ Manual de montaje - Página 7

Navegue en línea o descargue pdf Manual de montaje para Accesorios de vídeo profesional Flycam FLCM-DN-ABQ. Flycam FLCM-DN-ABQ 12 páginas. Dslr nano handheld camera stabilizer brace support

Imprimir página

Adding Weight Sand Positioning for Proper Balance

Continuing the assembly and balance requirements to make your FLYCAM DSLR Nano fully functional you

will note that the base platform has a provision to mount the balance weights in their cups via a slot found

on both sides of the post.

The purpose of the counter weight system is to match the low end of the stabilizer to the weight of the

camera and accessories at the high/top end with the gimbaled handle as the pivot point in between. The

heavier the camera and accessories, the more weights are required to achieve proper balance. Generally as

you add weight to one side of the central post, an equal amount has to be added to the other side to

maintain horizontal balance. However if you are using an offset configuration such as a flip out viewfinder or

off center accessories, extra weights might be needed on the opposite side of the post to counter act and

maintain proper balance.

Total weight fixed to the base platform should be equal to the weight of your camera plus the head and any

accessories.

Horizontal adjustment on the base platform is

made by loosening the retaining screws and

moving the mounted cups closer to or further

away from the stalk and then retightening. You

will probably need to adjust and re adjust the

horizontal

position

performance/ personal preference.

NOTE: When adding weight in the cups, use the

supplied foam spacers as silencers to prevent

metal to metal washer noise.

Vertical stalk Adjustment

The up and down (vertical) position of the

telescopic central post is adjusted by loosening

the control located at the base, raising or

lowering the stalk to the desired location and

then

retightening

Do not over-tighten this control.

Balancing Your Flycam Handled Stabilizer

Before beginning the balancing process check the following

•

Camera is securely attached to head plate.

•

Lens cap has been removed and secured.

•

Telescoping clamp has been tightened.

•

Weight discs are added successfully.

•

All screws are tightened securely.

•

Battery, all accessories and cables should be secured.

achieve

optimum

the

vertical

control.