Acer AcerSystem Manual del usuario - Página 29

Navegue en línea o descargue pdf Manual del usuario para Escritorio Acer AcerSystem. Acer AcerSystem 36 páginas. Acer aspire z3761 21.5 pw.sh0e2.011
También para Acer AcerSystem: Manual del usuario (32 páginas), Manual del usuario (27 páginas), Manual del usuario (16 páginas), Manual del usuario (41 páginas), Manual del usuario (17 páginas), Manual del usuario (27 páginas), Manual del usuario (30 páginas), Manual del usuario (30 páginas), Manual del usuario (41 páginas), Manual del usuario (28 páginas), Manual del usuario (32 páginas), (Spanish) Guía Del Usuario (43 páginas), (portugués) Manual del usuario (41 páginas)

Frequently asked questions

The following questions are possible situations that may arise during the use

of your computer and each is followed by easy answers and solutions to the

situation.

Q: I pressed the power switch but the system did not boot up.

A: Check the LED located above the power switch.

If the LED is not lit, no power is being applied to the system. Do any of the

following:

•

Check if the voltage selector switch located on the rear panel of the

computer is set to the correct voltage.

•

Check if you plugged the power cable properly into an electrical outlet.

•

If you are using a power strip or AVR, make sure that it is plugged in and

turned on.

If the LED is lit, check the following:

•

Is a non-bootable (non-system) diskette in the floppy drive? If yes,

remove or replace it with a system diskette and press Ctrl + Alt + Del to

restart your computer.

The operating system files may be damaged or missing. Insert the start-

•

up disk you created during Windows setup into the floppy drive and

press Ctrl + Alt + Del to restart your computer. This will automatically

diagnose your system and make necessary fixes. However, if the

diagnostic utility still reports a problem, then you may have to perform

the recovery process to restore your system to its original default factory

settings.

Note: For more information about recovering your system,

refers to the RCD instruction sheet.

Q: Nothing appears on the screen.

A: Your computer's power management function automatically blanks the

screen to save power. Just press any key to turn the display back on.

If pressing a key does not work, you can restart your computer. If restarting

your computer does not work, contact your dealer or the technical support

center for assistance.

Q: The printer does not work.