Ametek NSG 4070C-110 Manual de inicio rápido e instrucciones de seguridad - Página 6

Navegue en línea o descargue pdf Manual de inicio rápido e instrucciones de seguridad para Equipos de prueba Ametek NSG 4070C-110. Ametek NSG 4070C-110 20 páginas.

Imprimir página
AMETEK CTS
To reduce the risk of electric shock, do not remove parts from the housing.
There are no user serviceable parts inside the unit. Certain parts inside the instrument
work at mains voltage or at high frequency and are not provided with any protection
against being touched.
Only approved accessory items, connectors, adapters, etc. are to be used to ensure safe
WARNING
operation
The lines inside the device are not protected by a fuse. Therefore, the user must imple-
ment the protection of the device against short-circuits by means of suitable fuses.
Avoid an overload by taking suitable precautions.
In the event of a fault, dangerous and unexpected voltages may occur. Avoid touching
conductive parts unless they have been de-energized by suitable means and secured
WARNING
against being switched on again for the period of handling.
1.9

Operating Environment

Operate the equipment only in dry surroundings. Allow any condensation that occurs to evaporate before
putting the instrument into operation. Do not exceed the permissible ambient temperature, humidity or
altitude. Operate the unit not in explosive surroundings.
No objects filled with liquids, such as coffee cups, shall be placed on the unit.
Do not insert foreign objects in the ventilation holes.
Do not obstruct the ventilation holes (also on the underside). Ventilation should not be impeded by covering
the ventilation openings with items or other equipment.
Avoid high temperatures. Allow for sufficient heat dispersion when installed in a rack. Do not place the prod-
uct on radiators or fan heaters. The ambient temperature must not exceed the maximum specified tempera-
ture of this product.
Keep the test area clean and well lit. Cluttered or dark areas invite accidents.

1.10 Test execution

Check once again that all connections are proper including the ground and protective earth.
Remove any adjusting key or wrench before switching on or energizing the device.
The test area must be organized that no unauthorized persons have access during execution of a test.
Operating the product requires special training and intense concentration. Make certain that persons who
use the products are physically, mentally and emotionally fit enough to operate the products; otherwise inju-
ries or material damage may occur.
EUTs together with all accessories and cables are to be regarded as being live during the execution of a
test.
The safety instructions concerning all the instruments and associated equipment involved in the test setup
are to be observed.
The configuration of the test setup is to be strictly in compliance with the methods described in the relevant
standard to ensure that the test is executed in a compliant manner.
Working with high voltages alone is dangerous and prohibited by law.
The high voltages must be switched off when nobody is present.
Quick Start and Safety Guide
NSG 4070
6 / 20