Ametek Solartron Metrology Wigauge WHT Manual de uso e instalación - Página 8

Navegue en línea o descargue pdf Manual de uso e instalación para Equipos de prueba Ametek Solartron Metrology Wigauge WHT. Ametek Solartron Metrology Wigauge WHT 17 páginas. Wireless handtool

Imprimir página

5.0 Operating Modes

5.2.3 Preset

The current measurement is forced to a preset value and all subsequent measurements are taken fro this preset value. Preset can be applied either from

the WHT buttons or from the controller. To use the WHT button the button state must be first set up – see section 5.4 below on Button allocation. Preset can

only be cleared from the controller.

5.2.4 Scaling

The measurement from the WHT may be scaled by a multiplication factor. The scaling can only be set or cleared from the controller software

5.2.5 Max (Peak+)

The WHT can be set up so that the most positive measurement is displayed. This can be set up only from the controller. The MAX (PEAK+) can only be

reset from the controller.

5.2.6 Min (Peak-)

The WHT can be set up so that the most negative measurement is displayed. This can be set up only from the controller. The MIN (PEAK-) can only be

reset from the controller

5.2.7 Diff

The WHT can be set up so that the difference between MAX and MIN is transmitted. This can be set up only from the controller. The DIFF can only be reset

from the controller

All of the above modes are either continuous transmission or on a button press.

5:0 Operating Modes

502848 Issue 5