Doran 8000XL Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Accesorios Doran 8000XL. Doran 8000XL 6 páginas. Digital weight indicator
También para Doran 8000XL: Manual de instrucciones (5 páginas), Manual del usuario (7 páginas)

Imprimir página

1. The number of load cells connected to the indicator.

2. The operating temperature.

3. Whether or not the battery is fully charged after each low battery event.

Installation:

When installing a model 8000XL scale, locate the desired position for the scale

platform and indicator. The platform location should be flat, level and free of any

obstructions which might interfere with the operation of the scale platform.

Remove the platter and locate the bubble level inside the base. Adjust the four

scale feet so the bubble is centered with the base stable so it does not rock.

When installing your scale, make sure that the power connection is close to the

scale and easily accessible.

To mount the indicator to a wall, shelf, or counter, remove the "U" bracket from

the indicator by removing the two black knobs and washers. Use the two slotted

"keyholes" in the bracket as a template and mark the location for the mounting

holes. Drill two pilot holes for #8 screws at the marked locations. If mounting the

unit on drywall, drill the holes large enough to permit the use of wall anchors

capable of supporting a weight of 30 lb or more. Using two #8 screws, attach the

"U" bracket to the mounting surface, making sure that the slot portion of the

"keyhole" is pointed up.

Place the metal/rubber washers on the case studs with the rubber against the

case. Insert the left case stud into the left "U" bracket hole. Now gently spread

the sides of the "U" bracket apart and insert the right case stud into the right hole.

Loosely thread the two knobs back onto the studs. Adjust the indicator to the

desired viewing angle and tighten down the knobs to hold it in position. If the

indicator is attached to the platform with the optional "E" brackets, place the scale

on a flat level surface free from any obstructions which might interfere with the

operation of the scale platform. Level the base as described above.

Electrical Connections:

Prior to connecting your scale to power, check the serial number tag on the

indicator for the correct operating voltage. Verify that the power you connected

the scale to matches the rated voltage.

Be sure the AC power is not excessively noisy - this can occur if large inductive

loads, such as solenoids or motors, are on the same power line. The Model

8000XL has a filtered power supply to reduce the effects of normal line noise, but

they cannot limit severe fluctuations. If problems occur, noise producing devices

may have to be suppressed to minimize their effect.